|
ncguy24 |
|
|||
|
can anyone help . i want to put a eb gt steering wheel in my nc ghia is it a big job?? and do the cruise buttons conect the same way??
_________________ Only Milk & Juice Come In Two Litres |
|||
Top | |
Steady ED |
|
|||
|
Nah not a big job.
Get the horn pad off, disconnect cruise and horn wires, taking note of where they went!!!, undo the big nut in the middle, yank the wheel off, new wheel on, connect wires to horn and cruise buttons, tighten bolt, horn pad back on and done All connects the same way, as long the GT steering wheel has the boss on the back of it. Is this a woodgrain one off ebay by any chance?
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
Top | |
lil_lincoln |
|
|||
|
invest in some steering wheel pullers,it came off in 2 seconds rather then yanking on it.
_________________ |
|||
Top | |
BuNtEr |
|
||
|
use a rubber hammer when you take the horn pad off undo the nut up to the top, put your knees under the wheel and put some presure on it hit with rubber hammer and it will pop off its that easy,
even if you use the end of a hammer the wooden handle to hit it and it will come off.
_________________ BANNED |
||
Top | |
xfman1986 |
|
||
|
NOTE...LEAVE NUT ON TILL WHEEL COMES LOOSE...what i mean is half undo the nut bang the wheel to loosen it and then take the nut all the way off and remove wheel.
|
||
Top | |
ncguy24 |
|
|||
|
cool. thanks guys.
_________________ Only Milk & Juice Come In Two Litres |
|||
Top | |
EBIIexpress |
|
||
|
Make sure you line up any alignment marks on the inside of the steering wheel with the mark on the steering shaft. This will make sure that the indicators self cancel going around corners, something I found out when I replaced my EBII standard wheel recently with an aftermarket wheel.
_________________ EBII GLi sedan 4.0 MPEFI, high series head unit, C**k green, ABS, EB sedan 4.0 MPEFI, red, stock |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 64 guests |