|
| kpfien |
|
||
|
Had errors 33 and 73 on airbag system. After pulling off dash found the dummy resistor open circuit so replaced it with 2.2 ohm resistor as advised in various messages. However cannot reset the stored errors by taking pin 4 of top row to earth at any time or as suggested somewhere shorting pin 4 row 1 to pin 1 row 2. Is there any other method of resetting or do I need to replace the diagnostic monitor? What does it look like and where is it situated?
|
||
| Top | |
||
| Esteven8 |
|
|||
|
Have you read the tech doc on the SRS? If not, here is the link.
{DESCRIPTION} I had to keep clearing various codes off my EF for about a week when I first got her, so it may be a case of having to clear them one at a time.
_________________ {USERNAME} wrote: Cheap pads squeal like cheap hookers, and you can take that to the bank. {DESCRIPTION} {DESCRIPTION} |
|||
| Top | |
|||
| maso1988 |
|
||
|
just replace the airbag and put a new fuse in who cares abot error codes lol. If you put the fuse in it wont beep when you start the car
|
||
| Top | |
||
| kpfien |
|
||
|
RTA rules apparently require no airbag codes to be present. I followed the procedure in the Airbag writeup but they didn't work, hence the search for another way.
|
||
| Top | |
||
| maso1988 |
|
||
|
how are the RTA going to know that ? lol
|
||
| Top | |
||
| bry40l |
|
|||
|
if the airbag light is on it shouldnt be registered because obviously theres a problem with the system, i had to reset about 4 or 5 codes off mine and it turned out there was no problem with the system it has never thrown the light up again,
_________________ BF XR6 |
|||
| Top | |
|||
| bry40l |
|
|||
|
also i had a problem reseting mine at first go, ii had to leave the pins earthed for a while before they reset
_________________ BF XR6 |
|||
| Top | |
|||
| Esteven8 |
|
|||
|
{USERNAME} wrote: also i had a problem reseting mine at first go, ii had to leave the pins earthed for a while before they reset As did I. And the fact there were a few codes to clear as well.... But this was a good 6months ago and I haven't had any more problems since.
_________________ {USERNAME} wrote: Cheap pads squeal like cheap hookers, and you can take that to the bank. {DESCRIPTION} {DESCRIPTION} |
|||
| Top | |
|||
| maso1988 |
|
||
|
{USERNAME} wrote: if the airbag light is on it shouldnt be registered because obviously theres a problem with the system, i had to reset about 4 or 5 codes off mine and it turned out there was no problem with the system it has never thrown the light up again, I ripped the bulb out |
||
| Top | |
||
| bry40l |
|
|||
|
put the bulb back in and reset the system?
_________________ BF XR6 |
|||
| Top | |
|||
| maso1988 |
|
||
|
{USERNAME} wrote: put the bulb back in and reset the system? why ? too much effort lol it passes rego |
||
| Top | |
||
| bry40l |
|
|||
|
and if the cars crashed and they ask why it never went off and you say arr well the light was on so i took the globe out well then your in deep dooo doo im sure,
_________________ BF XR6 |
|||
| Top | |
|||
| maso1988 |
|
||
|
won't tell them
|
||
| Top | |
||
| maso1988 |
|
||
|
i'll just say i don't know i bought it like that
|
||
| Top | |
||
| snap0964 |
|
|||
|
Fix it properly - then you have peace of mind that it might save you injury in a collision.
Read the Airbag sticky in the interior forum. To reset codes, all the faults need to be fixed first. The system should beep if there's no bulb or it's blown - so don't waste your time pulling the cluster to do this.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 8 guests |
