|
| jamie22_cole |
|
|||
|
hey guys just went for a drive to get the dinner and my heater isn't blowing any warm air anymore it was working yesterday. ive tried turning the dial from hot to cold, cold to hot and still no change. im hoping it will be an easy fix whatever it is.
|
|||
| Top | |
|||
| Darcy4524 |
|
||
|
Blocked heater core or buggered heater tap.
_________________ NA2 fairlane - 3.9 with au headgasket & injectors, ef fans, 2.5" zorst, lowered on selby springs , kenwood head unit and 6 speakers, fusion sub, el ecu & ti chip |
||
| Top | |
||
| Mad2 |
|
|||
|
have you checked the heater tap and that the vacumm line is working?
|
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
haven't check anything yet as it is dark now so ill have to take a look tomorrow arvo after work. darcy4524 said blocked heater core how does that happen and can it be unblock if it is?
|
|||
| Top | |
|||
| Mad2 |
|
|||
|
normally a core gets blocked with sludge caused by using plain tap water
|
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
can it be unblock?
|
|||
| Top | |
|||
| Darcy4524 |
|
||
|
Yes it can be. You need to remove the pipes going tobacco side of the heater core. Then back flush the water with a hose and vice versa. Keep doing that until the water comes out clear. It was also be worth flushing the block and radiator.
_________________ NA2 fairlane - 3.9 with au headgasket & injectors, ef fans, 2.5" zorst, lowered on selby springs , kenwood head unit and 6 speakers, fusion sub, el ecu & ti chip |
||
| Top | |
||
| Mad2 |
|
|||
|
{USERNAME} wrote: You need to remove the pipes going tobacco side of the heater core. ok .... what am i missing re tobacco side??? |
|||
| Top | |
|||
| TedW |
|
||
|
check thermostat first-top and bottom radiator hoses get hot - temp. gauge ?
left rear of engine - check heater tap operates - lever should move -vacuum to tap ? - if vents change should have vacuum to system -tap may move but still be faulty internally - hose at heater tap should be hot in and hot out with heat on - blocked heater core -disconnect both hoses and check flow with garden hose to start with....... |
||
| Top | |
||
| Darcy4524 |
|
||
|
To both sides. Oops
_________________ NA2 fairlane - 3.9 with au headgasket & injectors, ef fans, 2.5" zorst, lowered on selby springs , kenwood head unit and 6 speakers, fusion sub, el ecu & ti chip |
||
| Top | |
||
| TedW |
|
||
|
{USERNAME} wrote: {USERNAME} wrote: You need to remove the pipes going tobacco side of the heater core. ok .... what am i missing re tobacco side??? ?????????????????????????????????????????????????????????? |
||
| Top | |
||
| Mad2 |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: You need to remove the pipes going tobacco side of the heater core. ok .... what am i missing re tobacco side??? ?????????????????????????????????????????????????????????? if you read the one before yours ... everything is explained.... |
|||
| Top | |
|||
| 96ELGli |
|
||
|
Hello,
Does the Temp. gauge look normal ? If it is very low the thermostat may be stuck open.
_________________ Regards 96ELGli |
||
| Top | |
||
| jamie22_cole |
|
|||
|
didn't need to check anything as it was working fine the next day but I have notice that it takes a while to change from cold to hot on the heater dial then same with the opposite. so im thinking it could be a faulty valve in the heater tap.
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |
