|
| James84 |
|
||
|
ok so i wanna hook up some fog/driving lights to my EF, and i want to use the dash illumination.
i have a Police cluster, and have read the TechDoc about it, but where does the 12v come from? ill be wiring up the lights as per the diagram below. Attachment: relay_wiring.jpg [ 17.14 KiB | Viewed 213 times ] so would i take 12v from the 86 or 87 pin on the relay for the dash globe? cheers. |
||
| Top | |
||
| james dio |
|
||
|
what you do, when you run your switch that is inside the interior to switch on the lights, just run an extra wire from the output of the power wire from the switch and then connect it to Pin 8 on the left hand side connector for the cluster
EDIT: it would be pin 86 on the relay to send a wire from it to the cluster |
||
| Top | |
||
| James84 |
|
||
|
ahh excellent! thanks mate.
|
||
| Top | |
||
| creeture3 |
|
||
|
Power should only come from your high beam circuit, so that the lights can only be turned on when high beam is activated, thus you need to tap into the high beam wire.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 52 guests |