|
| rooman79 |
|
||
|
hi since i bought my eb the horn and cruise dont work open to any suggestions to help me fix the problem. any ideas?
|
||
| Top | |
||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
the little spring loaded contacts behind the steering wheel are probably worn out
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| rooman79 |
|
||
|
hi yeah have the wheel off at the moment had look at that they seem to be touching the rings on the back of the wheel. i have access to a parts car which the horn and cruise worked on if i swap out pins would that be worth a try?
|
||
| Top | |
||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
yeh try that. to remove you just push them in and turn. my EB always wears them out. the horn works, the cruise will turn on and off but it won't set. it always murders the set/acc contact. so i just don't bother now. put grease on the rings to prolong the life
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| rooman79 |
|
||
|
or would it be better to just swap the whole indicators/wiper on the steering assembly off parts car?
|
||
| Top | |
||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
just change the spring loaded contacts. easier
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| nannas_ed |
|
|||
|
i had this problem a while back with the xr. cruise would light up but would not set a speed, horn also did not work. after an hour or so of trouble shooting with a workshop manual it was discovered that the cruise actuator was open circuit. replaced this and everything worked again.
_________________
|
|||
| Top | |
|||
| rooman79 |
|
||
|
yeah i have just been out and removed other indicator/wiper assembly of an nc fairlane which has different loom plugs so i think it a pin swap will be easier as suggested thank for help guys
|
||
| Top | |
||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
yeh thats why i said it. i had the same problem.
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| rooman79 |
|
||
|
hi thanks off to put it back together see if it works.Wildeb nice work on the car have browsed your work very nice
|
||
| Top | |
||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
is there a fuse for the cruise and horn. or a relay? never looked.
cheers by the way. 2 years in the making and counting. have you seen my second car? a EA SVO
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| rooman79 |
|
||
|
yeah that was a no go still not working it might be beyond my skill level/abilities.
just looked then at fuses all seemed fine well all the under dash ones were. yeah i have seen the svo very nice good pick up! be it gets some admirers! |
||
| Top | |
||
| rooman79 |
|
||
|
nannas_ed hi thanks for the input where is the actuator located?
|
||
| Top | |
||
| rooman79 |
|
||
|
i ran out of knowledge so took to a mate for help found that the front relay located near the batt was rusted the 86 pin had rusted of the relay. but ran out of daylight to fix it so pulling it out tomorrow to clean it up replace the relay see if that was the prob.
|
||
| Top | |
||
| lethal EA |
|
|||
|
{USERNAME} wrote: i ran out of knowledge so took to a mate for help found that the front relay located near the batt was rusted the 86 pin had rusted of the relay. but ran out of daylight to fix it so pulling it out tomorrow to clean it up replace the relay see if that was the prob. Any new info?
_________________ Black ED Ghia |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 36 guests |
