|
| howsie |
|
|||
|
Hey all i got a gauge holder (like in the GT's) for christmas and am unsure how to mount it as there are clips on it like the original cover has.
Basically i have heard that you cut a little slit in the dash and slide the back corner in then screw the front down. Has anyone got anymore detailed info on this. BTW i have no idea what brand it is it looks like someone brought it off ebay
_________________ Current cars |
|||
| Top | |
|||
| howsie |
|
|||
|
so i have mounted the holder and now just need to run the wires for the volt and vacuum gauges any ideas on where these can be run as there is little to no room in that area that i can see.
i should mention i have spent 3 hours searching other posts and nowhere mentions this
_________________ Current cars |
|||
| Top | |
|||
| Mohekn |
|
||
|
hey man, did u end up working out what to connect the vacuum hose to? i've installed the same gauges but have no idea!!!
_________________ Buy my car |
||
| Top | |
||
| howsie |
|
|||
|
no sorry although i have connected the volt meter i haven't done the vacuum yet its still too warm
_________________ Current cars |
|||
| Top | |
|||
| data_mine |
|
|||
|
If you got a FPV, the factory loom disappears behind the ICC, and runs along the firewall then into the engine bay.
Another option, is if you take the cluster out, you can get some wires up to the gauge area from behind the cluster, rather easily (much more easily than removing the ICC).
_________________ 1998 DL LTD in Sparkling Burgundy, daily, 302W, stereo, slow |
|||
| Top | |
|||
| howsie |
|
|||
|
i looked at taking the cluster out but was a bit timid of breaking something i might have another go
_________________ Current cars |
|||
| Top | |
|||
| data_mine |
|
|||
|
howsie wrote: i looked at taking the cluster out but was a bit timid of breaking something i might have another go There's 5 screws and 2 loom connectors, nothing much to worry about.
_________________ 1998 DL LTD in Sparkling Burgundy, daily, 302W, stereo, slow |
|||
| Top | |
|||
| howsie |
|
|||
|
yeah i can get the screws that no the problem. problem is i cant quite get my hand around to release the plugs
_________________ Current cars |
|||
| Top | |
|||
| data_mine |
|
|||
|
Unless you've got huge hands, the cluster does come out enough to get to them easily. I don't have small hands at all.
Takes some careful wiggling to get the cluster out (be sure to fully lower and extend the steering wheel).
_________________ 1998 DL LTD in Sparkling Burgundy, daily, 302W, stereo, slow |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 59 guests |
cause i just bought a BA XR6 