|
| metasaiah |
|
|||
|
I've almost finished my LED conversion on my EF GLi. Where I've run into trouble is that I can't figure out how to get at the globes that are in the aircon buttons. Do I have to remove the circuitboard or something? I can't see how to get the buttons out.
_________________ EF2 Fairmont Ghia. AU2 engine running EF gear. Intake, exhaust, injection etc; 8" rear stockies with 265/50R15 rubber. Shiftkitted auto, J3, custom grille and dash cluster and lots of other useless crap... |
|||
| Top | |
|||
| falcon_3512003 |
|
|||
|
did mine i had to pull the hole thing apart and solder in the led's myself pain of a job but can be done
_________________ now have a series 1 au starting the mods slowly |
|||
| Top | |
|||
| bazz |
|
||
|
i just put plug and play in mine and its good
|
||
| Top | |
||
| metasaiah |
|
|||
|
so again, how do you get access to the lights in the aircon buttons?
_________________ EF2 Fairmont Ghia. AU2 engine running EF gear. Intake, exhaust, injection etc; 8" rear stockies with 265/50R15 rubber. Shiftkitted auto, J3, custom grille and dash cluster and lots of other useless crap... |
|||
| Top | |
|||
| tonyb62 |
|
||
|
assuming you have a normal heater control not a climate control unit, there are two screws in the circuit board take both out then slide the board out the back. easy enough to come out, shouldn't have to force it.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 51 guests |
