|
| Sturmovik |
|
|||
|
Anyone notice the chrome handles more easily crack the plastic housing on them? I had to go to the wrecker and stockpile a few.
(ive got EL Ghia trims and handles in my ED)
_________________ 1993 ED XR6 5speed Polynesian Green. Project car. |
|||
| Top | |
|||
| Mash85 |
|
||
|
lukey wrote: Yeh I wanted just chrome too, no woodgrain, but when I put this one in it looked quite good so I'll keep it.
What I was gonna do before was just take out the shifter surround, tape off the gear selection section, and spray it with VHT chrome paint (made for plastic). Give it a try I rekon it'd look awesome.  i want the chrome just around the prndl selecter bit. its tempting to buy a woodgrain one, mask of he chrome bit and spray the woodgrain grey. be a shame to wreck a perfectly good woodgrain one tho
_________________
|
||
| Top | |
||
| 96ghia |
|
|||
|
Sturmovik wrote: Anyone notice the chrome handles more easily crack the plastic housing on them? I had to go to the wrecker and stockpile a few.
(ive got EL Ghia trims and handles in my ED) I've got an EL with the chrome handles, and both my Front Door handles cracked in this way. The rear ones almost never get used, so they're still allright... I think the extra weight of the handle, and that they are metal on plastic being pulled all the time makes them more suceptible to damage. |
|||
| Top | |
|||
| twirqurky |
|
||
|
Ive never noticed the cracking of the shells to be honest.
|
||
| Top | |
||
| Mash85 |
|
||
|
hmmm probably explains why they changed the later ones to plastic ones in the later el's
_________________
|
||
| Top | |
||
| malazn_mafia |
|
|||
|
how to remove the rollpin? tried forcing out with screwdriver and no luck...
|
|||
| Top | |
|||
| madmax |
|
|||
|
All I did was, push it out with small screwdriver until I could grab the other end with a pair of pliers. They are tight, but then you wouldn't want them loose.
_________________
|
|||
| Top | |
|||
| 96ghia |
|
|||
|
same here. I had cracking on my original housings, so I transferred my Chrome handles from the old to the new cappa housings, and this was all I had to do.
Just be careful getting back in on the new ones. they need a bit of force, but not too much!! |
|||
| Top | |
|||
| lukey |
|
|||
|
Once you get one rollpin out you can use that one to push the others out.
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 56 guests |
