|
| jumsmethod |
|
||
|
Im hoping to get some insight on how to fit a FORD EL FAIRMONT EF FALCON XR6 TICKFORD tacho dash into a Ford Falcon EL Gli, would it slip straight in or will i need other componants?
|
||
| Top | |
||
| TimmyA |
|
|||
|
is it the high series one (fairmont)? that is it has three plugs in the bottom and 1 in the back?
If so you wont have the plugs (GLi has two plugs) you'll need to cut off your and solder on the new ones, or make a patch harness adaptor, or something of that nature... or is it a XR6 one? these will fit straight in... Please read the tech docs section: High Series Cluster Install EF/EL Cluster Information Cheers, Tim
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| jerrytorry |
|
|||
|
timmytimtim wrote: is it the high series one (fairmont)? that is it has three plugs in the bottom and 1 in the back? If so you wont have the plugs (GLi has two plugs) you'll need to cut off your and solder on the new ones, or make a patch harness adaptor, or something of that nature... or is it a XR6 one? these will fit straight in... Please read the tech docs section: High Series Cluster Install EF/EL Cluster Information Cheers, Tim the fairmont ones had 2 plugs like gli and xr, it was the fairmont ghia that was different
_________________ |
|||
| Top | |
|||
| TimmyA |
|
|||
|
oh my bad... wasn't sure where that high series one started...
so fairmont ghias, lanes, and ltds would've had the high series one?
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| tony.martin11 |
|
||
|
i have a fairmont ghia cluster and its what they use in the standard fairmont Because you have:
Low Series: GLi, Futura Mid Series: XR, Fairmont Ghia High Series: Fairlane Ghia/LTD Low and mid series are interchangable but if going from low series to mid series, no additional wiring needed, all that has to be done is 1 resistor soldered into the back of the circuit board if you are doing the Low or Mid series cluster upgrade to the High Series cluster, you need to do the extra wiring
_________________ BANNED USER Last edited by tony.martin11 on Mon May 31, 2010 8:40 pm, edited 1 time in total. |
||
| Top | |
||
| jerrytorry |
|
|||
|
yeah, im pretty sure. i'v got one here out of a fairmont and it only has two plugs
_________________ |
|||
| Top | |
|||
| TimmyA |
|
|||
|
sounds good to me...
yeah he said its both a fairmont one and an XR6 one so it threw me as to axactly what it was... But if they are both the same then... easy straight swap over...
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| tony.martin11 |
|
||
|
Well i thought i'ld just try to clear it up for you
_________________ BANNED USER |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 70 guests |
