|
| EL2XR8 |
|
|||
|
Hi guys,
does anybody know what size bolts are needed for the armrests on rear power window door trims (2 of)? Also what's the max length they can be before touching the glass when it's down. I've just done a rear conversion. It an EL. Thanks.
_________________ EL II XR8
|
|||
| Top | |
|||
| Krytox |
|
|||
|
90% sure I think i used M8 35mm.
(i bought the rivnuts tho.)
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| EL2XR8 |
|
|||
|
just from a bunnings type of place?
_________________ EL II XR8
|
|||
| Top | |
|||
| Krytox |
|
|||
|
yeh, anything that fits.
You'll have to add a captive nut... on my fronts i cut a slit and put one of those clip nuts on... like on early holdens.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| horis |
|
|||
|
i just got the nuts that go in the doors like a press fitted style and fitted the there is a docco on this some where shows how to fit them and might actually give a part number will try and find it for ya as i did a full power window acc fairmont dash all that s**t to my old mans gli
_________________ 95 ef montfor sale pm for info, 88 hilux mud truck |
|||
| Top | |
|||
| EL2XR8 |
|
|||
|
thanks horis, i tried a M8 20mm allen key bolt which did fit but thread wasn't long enough. I couldn't find an M8 35mm as Krytox advised to use but it should do the job if I can find a set of 4.
_________________ EL II XR8
|
|||
| Top | |
|||
| EL2XR8 |
|
|||
|
Had no luck with any M8's, too small, if I go to M10 then I need to use a socket and there's no room to go through the hole on the door trim.
Found this in the technical document section: "8 x Door Nut Rivet M6 (Available from Ford for $0.80 each) - Part Number V820134S" I'd be better off just getting them from Ford?
_________________ EL II XR8
|
|||
| Top | |
|||
| madmax |
|
|||
|
EL2XR8 wrote: Had no luck with any M8's, too small, if I go to M10 then I need to use a socket and there's no room to go through the hole on the door trim.
Found this in the technical document section: "8 x Door Nut Rivet M6 (Available from Ford for $0.80 each) - Part Number V820134S" I'd be better off just getting them from Ford? If they are what I think they are then you will need a riv-nut gun to install them. Essentially they are a rivet with a nut in the middle of them.
_________________
|
|||
| Top | |
|||
| horis |
|
|||
|
you dont need a riv nut gun to install them as this is what i was trying to explian before these are the riv nuts that secure in the door to mount the arm rest to secure to all u need to do is get a m4 or similar and tighten the nut on the back as to compress the riv nut did this to all 4 doors on my old mans gli worked a treat
_________________ 95 ef montfor sale pm for info, 88 hilux mud truck |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 82 guests |
