|
| dylanfh |
|
||
|
Any ideas if a BA Auto shifter handle will fit an AU3 without any mods?.
|
||
| Top | |
||
| Disco Frank |
|
|||
|
nope
_________________ RIP SCOTT |
|||
| Top | |
|||
| dylanfh |
|
||
|
Disco Frank wrote: nope Holy s**t you have alot of posts,sorry had to add that. Also curious,how come it wont fit?. |
||
| Top | |
||
| frd906n |
|
||
|
au uses linkages and ba uses a cable set up
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| Disco Frank |
|
|||
|
frd906n wrote: au uses linkages and ba uses a cable set up thats the operation of the box nothing to do with the handle the actual insides of the handle are different could be done if u where able to mate the BA handle onto the AU shifter shaft iirc there is a member here who has put a BA shifter and surround into a EB/ED i think
_________________ RIP SCOTT |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
dylanfh wrote: Disco Frank wrote: nope Holy s**t you have alot of posts,sorry had to add that. Also curious,how come it wont fit?. been around a while   see above post to why
_________________ RIP SCOTT |
|||
| Top | |
|||
| frd906n |
|
||
|
Didnt ozbmx do the ba shifter mod to his ef
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| OZBMX |
|
|||
|
Yeah I had to make a plastic shim spacer due to the ef/el having a much thinner shaft
and a couple wedges as the ba lifts a rod to converts the upwards motion to downwards motrion. to push the rod down, but was defintaely worth it. I'd consider the whole tiptronic Idea but didn't want to lose the woodgrain, always felt that sprayed silkver a little tacky looking had the insert painted to in a charcoal, was hoping to get a woodgrain insert but went 5spd instead. au will be a bit different again suspect doable, but it isn't a 5 minute job to get right.
_________________ Signature removed by moderator.signature must not exceed 120x500 pixles |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 97 guests |
