Hi all,
I've an Emmegas DEG-104 stepper unit here pulled out of an EF V8.
I need to be able to reprogram it - it requires special cables and software though.
While I should be able to get the cabling sorted, the software remains an issue.

Does anyone have a copy of the software for this model around?
If someone can get it for me, I can then put it up on hosting for everyone if that's ok.

Any help appreciated ::)

have a look at this site,
http://www.lpg-kits.com/interfaces.htm
got my cable and software through them.

Thanks mate, I'll hop over and check the applist.
I did see that mob when I was browsing around but didn't know if they were any good. So much crap on the net since it went commercial
Thanks for the recommendation!