|
| ghia97 |
|
||
|
Im just wondering after having a major backfire and having the pcv valve smash into the head putting a small hole approx 1.5cm x .5cm in the bottom of the alloy head directly under the pcv what are the chances of long term survival of the engine with a small hole in the head. All of the damaged pcv was removed from engine so there isnt anything floating in there. The car has been driven like this for a while and there is no noticeable difference.
|
||
| Top | |
||
| 97GLIWAGON |
|
||
|
Hmmm im thinking this could've happend to my enigne now....Bugger!
|
||
| Top | |
||
| relaxed_diplomacy |
|
||
|
A short time ago i spoke to a parts man at a Ford dealership and he said that after backfire the pcv innards can end up in the timing chain, if it jumps then bang! . . . engine dead.
_________________ wrecking 9/97 EL fairmont sedan burgundy 6cyl auto 270k modBAintake |
||
| Top | |
||
| Krytox |
|
|||
|
I think the 'damage' you'll find will be the oil drain hole.
Did you happen to retrieve a single ball bearing? this can cause a very bad timing chain mishap as stated above. If it made it to the sump, then she'll be right mate'!
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| Rick's EF Fairmont Wagon |
|
||
|
Note to all
there is a revised METAL PCV valve that must be fitted when GAS is fitted to avoid this problem. This was in a ford bulletin
_________________ BF3 Egas XT Wagon |
||
| Top | |
||
| ghia97 |
|
||
|
Thanks guys. I fished out the metal rod and spring but i didnt see a little ball bearing. The car has been driven 5000kms in this state now with no problems so i would say all is good.
|
||
| Top | |
||
| xcabbi |
|
||
|
{USERNAME} wrote: Note to all
there is a revised METAL PCV valve that must be fitted when GAS is fitted to avoid this problem. This was in a ford bulletin Then why the hell do the pricks still sell plastic ones? |
||
| Top | |
||
| Krytox |
|
|||
|
{USERNAME} wrote: Then why the hell do the pricks still sell plastic ones?
Price.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
and i would say u need to ask for the metal pcv valve
if u ask for a pcv valve they would give u the plastic on dude sounds like the ball bearing made it into the sump yu are lucky 
_________________ RIP SCOTT |
|||
| Top | |
|||
| TROYMAN |
|
||
|
or you can use the metal pcv from ea/ed..
i dont run lpg but im using a metal ea pcv in my au engine and it works fine! |
||
| Top | |
||
| ghia97 |
|
||
|
Yep it was the oil drain hole lol not pcv as i thought, has metal pcv on there now. Fraud shouldnt sell plastic ones or ask if vehicle is on lpg at least.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 10 guests |
