hi

which is better out of a secondhand impco 225 mixer and l converter or a LPG VAPOUR INJECTION CHEAP GAS EFI KIT in http://www.ebay.com.au/itm/LPG-VAPOUR-I ... 2c5cac7c7f in a ed fairmont with au engine and ed xr6 ecu

whats needed to get the LPG VAPOUR INJECTION CHEAP GAS EFI KIT working in a ed fairmont with au engine and ed xr6 ecu

is secondhand lpg kits that are not very old ok

Impco gear is proven for long term reliability. In comparison to Impco those Ebay vapour kits have been around all of about 5 minutes.

It's up to you what you want.

how do you make the factory ed petrol gauge worh when your on gas with a impco cdp-oz or impco commander processor with impco 225 mixer and l converter

is second hand impco gear ok as long as you get a good or new tank, use new solinoids, new seals in the tank sender and solinoid if its a 2nd hand tank, new lines and its not too old

hi

does this gas ecu work with mga converter/mixers

http://cgi.ebay.com.au/ws/eBayISAPI.dll ... K:MEWAX:IT

and does this mixer work with a mga converter http://www.ebay.com.au/itm/LP-GAS-OUTLE ... 3365563fb8

If I was you, I wouldn't mix & match components, get a full kit for much less hassle. Impco 225 if setup right isn't a bad system at all, but will limit you power wise down the track. So will the cheaper injection systems.

Only issue I see with the injected kits on Ebay is the reliability of the injectors, but if they fail there are other options available to fit to the kit. Check out Ebay in the UK for what might be suitable.

I had gas injection installed on my EB Ghia back in 2004, yes that's correct, 2004. No BS. I did over 200,000kms, most of them on LPG before I had an injector failure. Sourced a replacement injector, no further issues.

Cheers

ToranaGuy