|
| JOSE |
|
|||
|
|
|||
| Top | |
|||
| phongus |
|
|||
|
hmmmmm. might need a new engine for my EA......if its worth it. would it fit in an EA btw?
cheers phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Rapier |
|
||
|
need to modify ure k frame to fit it in afaik
|
||
| Top | |
||
| phongus |
|
|||
|
ohhh okai......might need to think about that one. probably end up upgrading to an EF-EL or something.
cheers phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| XRated |
|
|||
|
{USERNAME} wrote: need to modify ure k frame to fit it in afaik
Or grind the front of the AU sump off. |
|||
| Top | |
|||
| JOSE |
|
|||
|
with whats included there youd need to do some modifying, the ribs on the front of the AU sump have to come off, and a lot of grinding to get your balancer on, but its not impossible
_________________ Because i can. |
|||
| Top | |
|||
| fordman351 |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: need to modify ure k frame to fit it in afaik Or grind the front of the AU sump off. NO! I have been looking into this and grinding the front of the sump off weakens it. It may leak after a while apparantly. Talk to "twason" about this one, VERY knowlegable about AU engine conversions. |
|||
| Top | |
|||
| The_Jackal |
|
|||
|
im using the ef sump, dont need to touch the k frame, you just have to have the rear bearing i think it is machined and it goes in piece of piss.
_________________ EF XR8 - 5speed, Extractors & Exhaust |
|||
| Top | |
|||
| fordman351 |
|
|||
|
Modifying the k-frame is no biggie, plus the cast sump on the AU engine gives better block rigidity, not that much more, but every bit helps eh?
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 22 guests |
