I have lot's of stuff I need to clear for space and credit card consolidation

Garrett T04 Turbo- $550- Very good condition, see pics for size comparison against XR6 turbo (GT3540), more specs available upon request

HKS copy Wastegate- $160- Brand new and comes with flanges/bolts ect. (16psi spring, can be cut or replaced for lower psi setting)

3" Aluminium intercooler/intake plumbing- $P.O.A. Various bends from 45*-90*-180* Ideal to go from Intercooler to throttle body, surplus to my needs

3" Aluminium doughnut

Intercooler clamps- $2 each -7mm bolt will heaps available

3" joiners- $P.O.A.- cut to length usually 3" long is enough, thermalflex silicon (US brand)

Jaycar Digital boost controller fully assembled with hand controller, HKS solenoid and data cable- $P.O.A. only available to sell after I have tuned Pauls car with the hand controller, I bought this before finding out the XTC EMS can do dual map closed loop boost control

Diff gears- $50- 3.23 ratio from EF diff good condition

BA XR6T cat converter, will have to be flanged, apperantly has only done 500km's before entire exhaust was removed- $offers

RX7 series 5 airbox with HKS air filter- $40- comes with airbox, filter and snorkle

AU Fairmont Ghia 16" rims- $350- Front tyres @80% (Suimoto performance 225/50/16, Z rated) Rear tyres around 50% (Dunlop sports 215/55/16) but will sell for $300 with toasted rear tyres

T04 on the left (for sale) GT35/40 on the right (not for sale, for size comparison)

Ballpark figure for the cat? Got a pic?

how much for the can of Cougar

can of cougar is free with any purchase

make me an offer on the cat, Has to be worth my while cutting it off the dump/down pipe. I'll get a pic tommorow (still has the heat shielding around it)

do the intercooler pipes/bends fit anything in particular or just random pieces?

they are the bends that you take to your welder to cut to the right length's and weld up to do your intercooler piping, The doughnut gets cut into whatever angle is required.

For example to go from the throttle body in an EF/EL/AU/BA you would use 180* bend+90* bend+45* bend +90* with lengths of straight pipe

bump!

bump!

ill take the diff gears off you,
how much will this improve over my standard ratio?(car is a base EBII not sure on ratio)
and how hard are they to fit?
can they be put into an LSD?
also finally where abouts in perth are ya?
cheeres
steve

Im In Carine, yes they will work with an LSD diff, it's been a while since I removed them so I couldn't tell you how hard they are to install but I would expect it's an all day job for someone inexperienced without a rattle gun.
They will improve your in gear acceleration and allow you to take off quicker, the car will "feel" like it has more torque.

PM me for my mobile number to arrange pickup

how much for intercooler pipes and post to maffra vic 3860?

depends on how many of the bends you want.

There is a total of
1x45*
2x90*
2x180*
1xstraight length

the doughnut is 2x360* halves

i want enough to do an el,i just got a stage 3 snort kit

so you will need the silicon joiners and clamps yeh?

yeah,and postage