All equipment is BRAND new in boxes

All GTO series
• Plus One (patent pending) woofer cones - The GTO936 has a cone with more surface area than competing models of the same size. The benefits of Plus One are greater efficiency and bass output.

• Edge-driven Kaladex tweeters - These are not commonly used w-domes, but full edge-driven domes like those found in higher quality home audio speakers. The benefits are increased power handling, reduced distortion, and increased efficiency. This technology also allows for better integration with the mid/woofer

• Hi-roll rubber surrounds are used to provide excellent cone-edge suspension and damping. In addition this material will not break down due to UV contamination or moisture.


626C - 6.5â€￾ 2 way co-axials $117 ( x 2 pairs)



936C - 6 x 9’s 3 ways $137 ( x 2 pairs)



Subwoofer

• New proprietary frame, unique in-board motor structure and new cone design deliver a woofer that is a full inch shallower than equivalent sized models from competing brands. This approach allows for fit into more vehicles without a sacrifice in performance.

• Progressive spider provides better control at excursion limits and reduces woofer distortion.

• Hi-roll rubber surrounds provide exceptional cone edge suspension and long-throw linearity with the proper amount of control and stability at excursion limits.

• Vented polepieces provide additional cooling to the motor structure, resulting in an increase in the subwoofer's thermal power handling capability

1202D - 12â€￾ dual 2ohm w/cast frame – 300rms 91dB sensitivity $134



Amps

75.4 - 4 channel CEA 2006 compliant (meaning power has been independently tested and verified) $389 ( x 2)
4 x 104rms @4ohms
2 x 284rms @ 4ohms


High-output MOSFET power supply ensures optimum power delivery into numerous impedances with low distortion.

Two variable 12dB per octave electronic crossovers.

Full range preamp outputs are provided facilitating multiple amplifier hookups without the need for high-loss Y-adapters or signal splitters.



755.6 - 6 Channel CEA 2006 $459
4 x 60rms @4ohms
2 x 107rms @ 4ohms

2 x 160rms @4ohms
1 x 300rms @ 4ohms


High output MOSFET power supply ensures optimum power delivery into numerous impedances with low distortion.

Three variable 12dB per octave electronic crossovers

Optional remote bass level control available.







1200.1 - Monoblock CEA 2006 $555
787rms @4ohms
1,114rms @ 2ohms

High-frequency Class D switching power supply. This topology is more efficient that traditional Class AB designs, drawing far less current from your vehicle charging system.

12dB per octave electronic crossover
Full-range preamp outputs facilitate use of multiple amplifiers without the need for noisy and expensive adapters or signal splitters.

A variable bass boost circuit is provided to optimize system response.

Optional remote level bass control available



Donation made to FORDMODS for all equipment sold.

Last edited by pyroay on Thu May 11, 2006 10:19 am, edited 9 times in total.

the 6.5' splits would they fit in front doors of an EF? Are they still availible? Do they need an amp? would u send to SA?

PM me with any info i want those 6.5' splits. cheers mate

ill pay extra for postage

As with all 6.5â€￾ speakers you will need a little MDF circle to allow it to mount in the doors. Takes about 5min to make 2 of them and then they fit fine.

For other specs check out the JBL website.

Boy keen for the splits. They are good speakers. I have used the 6.5" 3 ways on a number of installs and they habdle a fair bit of power.

Have the splits been removed, dont see them there.

aaron price on 4ch amp and some cable? ur a champ

cheers, greg!

damn wish I these came up for sale last week. I dont see the splits either.

Yes both pairs os splits sold in about 20min.

Amp prices are shown and cable depends on what you want.

I have DLS 0ga in Blue for half price $17.5m instead of $38

or welding cable 50mm2 for $6.5m

hey aaron, can i get a package off u? some amp cable, prolly 4gu or larger. one of your 4 or 6 chanel amps depending on prices, and one of the 12" subs, cheers

greg !

With the 6 chan can you bridge the 2 107watt channels and leave the other 4 at 60 or do you have to bridge the 4 into 2 and the 2 into one?

great gear for sale!

hey worp. no sorry this is not possible, the 2 bridged chanels actually take up four chanels hence why u only have 3 chanels instead of 6 when bridged, altho if you want to run 2 subs and some speakers run ur subs in parallel off the 6th chanel and run all ur other speakers off the amp unbridged

hope this helps, greg.

Just want to run 1 sub and 4 speakers off it, i guess i will have to get a 2chan and a 4chan amp.

how much for the 2 x 12" subs?