Following camshaft is for sale. Its brand new still in the box. Story goes - Australian Post told me that they lost this cam, so i re ordered another one under insurance. Than Australian Post tell me that they located the first cam and now i have two. First cam has been installed in my new engine via Ford stroker in USA, second cam is returning home on my engine pallet being shipped next week. So grab your self a bargin, this is a custom grind cam specifications for a 347 short engine with Trickflow 170 heads ( although I upgraded to TFS 190 heads after I had ordered, so both are fine) I ve also got TFS R series manifold with a 75mm TB.

The below camshaft is for sale – still new in the box, 20% off retail.
The information below is from the spec sheet that came with the camshaft in the box
FTI Sale Price - $379.00 MY Sale Price - $300.00



http://www.FlowTechInduction.com
Custom Camshaft Spec Card

SBF – StreetSweeper-30XL-HR12 +3*


Intake Exhaust

Valve Adjustment: .000” .000”
Lobe Lift: .373” .362”
Gross Valve Lift 1.60 Ratio: .598” .579”

Duration @ .050” Tappet Lift: 230* 236*

Lobe Separation: ­­­ 112*

Recommended Intake Centerline: 109*

Specs at 109 Degree Intake Centerline:
Valve Timing at Open Close
.050” Tappet Lift: Intake: 6* BTDC 44* ABDC
Exhaust: 53* BBDC 3* ATDC

Degree this camshaft using these specs provided on this sheet. The asymmetrical design of these lobes may not allow for accurate reading using the centerline method

This camshaft is designed for naturally aspirated, street/track applications
Other uses will not be optimized if this cam design is used

CHECK and verify rocker arm geometry, push rod length and lifter preload
This is imperative for optimum performance of this camshaft

The power band is roughly between 3000 to 6000 RPM with 327-347 CID
The power band is roughly between 3300 to 6200 RPM with 306-311 CID
Gear vehicle accordingly

The preferred minimum valve spring pressure is 150#-155# on the seat
PAC Racing 1207, Comp 26925, Lunati 73925 or equivalent springs required
Lightweight tool steel or titanium retainers and hardened valve locks required
Hardened, heavy wall push rods required for high RPM valvetrain stability

Large diameter, long tube headers and free flowing exhaust system required
High flow, aftermarket cylinder heads and intake manifold required

Lubricants with a high zinc content required for long-term endurance
This camshaft core requires a steel, OEM compatible distributor gear

It is highly recommended to check and verify piston to valve clearance
Failure to do so may result in serious cylinder head and engine damage

Re attached images.

First image is of my new engine - which has the first cam in it... so as you can see, this is a high quality build which should give you an idea about the quality of the camshaft for sale. Ed Curtis at FTI is world renown for his cams... heaps of companies try copy his grinds but they can not get it right. + I had to wait in line for 2 months to get this cam... that how in demand he is;-)

Second image is of the camshaft with the spring upgrade set. Only camshaft is included in this sale

 

 

Attachments:

munro1.jpg [ 151.03 KiB | Viewed 310 times ]

DSC_0187.jpg [ 401.39 KiB | Viewed 299 times ]