I have for quick sale a complete pre crossflow 250 2V motor. Very rare - made only in 1971 and very desirable for older Falcons... this motor was running fine when it came out to make way for a 351 in an XB coupe. I'm looking for around $500 but am willing to take offers, I have to make room.

Also have a single rail 4 speed, OK cond, $150 out of an XB. Also have bellhousing & clutchfork to suit same, as well as another bellhousing for x flow to single rail.

Also have a set of 4 mags suit Ford, 14 x 7 or maybe 8, haven't really measured them, with tyres - $100 for quick sale.

Might consider trade for: pair of good XB front guards ; XA - XC console ; pair of alloy rocker covers suit Cleveland..

PM me if interested in any of this stuff...

 

 

Attachments:

File comment: crappy quality pik, sorry - pm me and I can take better piks falcmtr.jpg [ 23.32 KiB | Viewed 1336 times ]

can you put up a pic of the mags?

no worries, added two piks of the mags and one of the 250. Mags look good, tyres are in OK cond but look to be retreads...

Motor is good, just been sitting for a while, hence its filthy state....

 

 

Attachments:

engine.JPG [ 135.34 KiB | Viewed 135 times ]

mags1.JPG [ 127.2 KiB | Viewed 122 times ]

mags2.JPG [ 82.42 KiB | Viewed 110 times ]

Have you still got the motor? Does it come with the manifold & extractors or just bare motor?

Hi, I have the complete running motor, as seen in the photo above. Basically the car was running fine when it came out - the last work that motor did was drop the kids at school, then drove up the ramps to pull it out..it would still be in there if I didn't replace it with the V8. Comes with all manifolds, starter, alternator - flywheel for manual still on the motor, bellhousing for 4 speed if you need it.

Oh, and extractors of course (they're Genies...)

PM sent...