|
| Nicko |
|
|||
|
Ok - thanks for the pm. Sounds like a big job!
so what ratio is this?
_________________ Nicko |
|||
| Top | |
|||
| EB91XR6 |
|
|||
|
if its not too hard can u send me the same pm for my EB as would like a tight lsd, need to know how hard instelation is
_________________ 1976 XC falcon
|
|||
| Top | |
|||
| stockstandard |
|
|||
|
Changing the center involves removing the diff cover plate, rear brakes, axels, popping the old center out, removing the crownwheel, bolting crownwheel to new center and then putting it all back together. Thats assuming the new center already has bearings on it and doesnt need any shimming.
Its not hugely difficult (there are a few tricks) but its not changing the spark plugs either.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| Brett 4777 |
|
||
|
thanks for that stockie
and no it doesnt have any bearings on it as then whoever buys it can put their own preferred bearing on it still here too |
||
| Top | |
||
| ef biff |
|
||
|
pm sent
|
||
| Top | |
||
| Nicko |
|
|||
|
Very cheap Brett - ill stop s**t stirring you now!
_________________ Nicko |
|||
| Top | |
|||
| ef biff |
|
||
|
$350 including fitting? ill take it.
|
||
| Top | |
||
| Brett 4777 |
|
||
|
biff do you know how much work is involved to make your 3:7 gears
fit properly if you do that you need all new bearings around $300 plus the lsd is $300 labour charge is $100 to $150 to do the job so in short no i cant fit it for $350 |
||
| Top | |
||
| Brett 4777 |
|
||
|
still here guys
$300 and its yours |
||
| Top | |
||
| Brett 4777 |
|
||
|
how much are people prepared to pay for this
as it needs to go |
||
| Top | |
||
| Brett 4777 |
|
||
|
lsd has now sold
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 20 guests |
