|
| SVO XR6 |
|
|||
|
the only way to use a reg on a turbo, is a high ratio reg. you wuill have to get it on a dyno to see how the AFR is
_________________
|
|||
| Top | |
|||
| EFFalcon |
|
|||
|
stop f**k around and just get an aftermarket ECU.
_________________ FALCN6 - EF GLi Turbo, 20" Rims, Air Bag Suspension, Straight LPG, 225rwkw |
|||
| Top | |
|||
| fritzz |
|
|||
|
i am need more money. just had to pay 1700 for insurance, i rang every insurance place and the only place that would do it was "justcars" they are great!!
_________________ # 1997 EL Falcon GLI - 600+rwkw |
|||
| Top | |
|||
| EFFalcon |
|
|||
|
aah.. just cars generally won't touch it unless its legal
is urs legal ? 
_________________ FALCN6 - EF GLi Turbo, 20" Rims, Air Bag Suspension, Straight LPG, 225rwkw |
|||
| Top | |
|||
| kermey |
|
|||
|
turbo off ebay? how much???
|
|||
| Top | |
|||
| rusty_ute |
|
|||
|
she'll run pretty lean on standard ecu, wont take much to destroy itself
_________________ mm, unlikely. |
|||
| Top | |
|||
| fritzz |
|
|||
|
got the turbo for 360. its got a .84 trubine housing and .70 comp with a 66mm wheel. at 1/2 throttle it starts spooling at 2000 and starts to com on hard at 2800. there has been no detionaton or pinning so far. its just the map sencer doesnt like the boost to much
_________________ # 1997 EL Falcon GLI - 600+rwkw |
|||
| Top | |
|||
| EDXR8 |
|
|||
|
{USERNAME} wrote: its just the map sencer doesnt like the boost to much
The MAP sensor doesn't read boost at all, only vac. A higher rate rising rate reg may help richen up the mix under boost, either get one of them and back off the timing a bit or keep off the boost until you get the aftermarket computer, otherwise you will get really good at replacing head gaskets. Last edited by EDXR8 on Mon Nov 28, 2005 12:46 am, edited 1 time in total. |
|||
| Top | |
|||
| EFFalcon |
|
|||
|
not to mention an AU headgasket raising compression, increasing the likely hood for pinging.
_________________ FALCN6 - EF GLi Turbo, 20" Rims, Air Bag Suspension, Straight LPG, 225rwkw |
|||
| Top | |
|||
| fritzz |
|
|||
|
ok cool thanks for your help anyway. ill let yous know how it goes when i start mukin around with a few things
_________________ # 1997 EL Falcon GLI - 600+rwkw |
|||
| Top | |
|||
| South |
|
|||
|
Let me get this right, you spent roughly $1200 on a manifold, $1500 on an upper intake plennum and thousands of dollars more on the associated parts, and you slapped on an el cheapo turbo from ebay?
You also have hoses as injectors and standard ecu running all of this? Im calling BS on this!
_________________ Fulli Sik Re |
|||
| Top | |
|||
| pyroay |
|
|||
Age: 44 Posts: 2121 Joined: 14th Dec 2004 Ride: FG Turbo Territoty Ghia Location: Traralgon |
Dont want to sound harsh man but i believe right now this turbo is going to cost you $6,000 more to get running properly. Let my comments sit here and in 6 months come back to them and look at the figure i've outlined...
I have stated many time before dont start a turbo project unless you have $12,000 to play with.
_________________
|
|||
| Top | |
|||
| AKO |
|
|||
|
The engine cutting out is due to lean out. The ecu see's lean fuel burn and cuts the spark. Take it fom someone who f**k around with standard ecu, walbro pump and 12:1 rising rate reg, get bigger injectors and a Wolf 3D or EMS 8860. After 4 blown head gaskets and 1 destroyed motor I finally had the EMS and 42 lb Ford Motorsport injectors fitted and tuned (the silly thing is I already had them but was too lazy to have them fitted
 ). The AU head gasket will only prolong the inevitable.
_________________ The artist formerly known as seton005 (and allegedly The_Murph).
|
|||
| Top | |
|||
| Steady ED |
|
|||
|
{USERNAME} wrote: aah.. just cars generally won't touch it unless its legal
is urs legal ? 
That insurance money you just spent Fritzz is going down the drain. Unless you've got it fully engineered and EPA approved. I'd cancel that policy, get the refund, leave the car in the garage till you can get a proper ECU and can afford to get it tuned. It will save you money in the long run.
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| ebs_4l |
|
||
|
{USERNAME} wrote: I have stated many time before dont start a turbo project unless you have $12,000 to play with.
i couldnt agree more with that comment, im doing my setup myself, and although i have gone fairly overboard on things considering my hp level i want, ive spent around 12k already.... MAN, i wish i knew where it all went.... i would have never previously thought possible for it to cost that much, but it does
_________________ EB 4L, 8.4:1, R154, GT4202r, 4in exhaust, Greenslade Engineering exhaust manifold, plenum chamber, 90mm throttle, Garrett W2A cooler, Surecam custom, autronic SM4, Bosch 120lb, Crane HI-6, LX-92, LM-1, Turbosmart Reg, 2x bosch 044, turbosmart 48 gate. 470kw+ @ 18PSI |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 25 guests |
