|
| redrocket |
|
||
|
3" Inlet Diameter : 2" outlet
INTERNAL WASTEGATE Wet Floating Bush Bearings : 1/8 NPT oil inlet T3 Flange : Fits T3 and T3/T4 Manifolds Specs: . 50 a/r compressor .63 a/r turbine .57 trim just woundring if this would be a nice size for 3.8 to 4lt engine? wet floating bush bearing is this good? |
||
| Top | |
||
| nick81xd |
|
||
|
too small
|
||
| Top | |
||
| xcabbi |
|
||
|
I think that's even too small for a VL engine.
|
||
| Top | |
||
| Denim |
|
|||
|
I had a new T3/T4 but, found out was a lil too small in the exhaust department, so I sold it to a mate who had a T3 Garret in his VL 3.0L, he put it in and was rapt to the eyeballs, went harder than his T3...
_________________ Denim (BAXR6) nothin like a couple of Eaton M90's on, to show whos BOSS.... |
|||
| Top | |
|||
| EBXR8380 |
|
|||
|
Far too small the 57 trim is small also...
A T3/4 hybrid is the go as in Presicion SC61-3 Get a Master Power T70 they are just on $1k shipped...
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 46 guests |
