|
| Sik_Cordz |
|
||
|
hey guys just want to know where i can run my boosr gauge and ext gate to. can i use the map sensor hose, or the hose that go;s into the fuel reg
|
||
| Top | |
||
| ed_man |
|
|||
|
Any hose that runs off inlet manifold vac will do.
_________________ God save Allan Moffat, God bless d**k-Johnson and thank Christ for Marcos Ambrose......... |
|||
| Top | |
|||
| twr7cx |
|
|||
|
I just used the line to the MAP sensor. Prolly not ideal since you want the MAP to have a nice reading but it'll do fine!
|
|||
| Top | |
|||
| Sik_Cordz |
|
||
|
could i use the line that go's on the top of the fuel reg
|
||
| Top | |
||
| HiBoost |
|
||
|
Sik_Cordz wrote: could i use the line that go's on the top of the fuel reg
yep just get a t piece, and use that .....
_________________ 4LTR-JET: 9.1 @150mph!! |
||
| Top | |
||
| Sik_Cordz |
|
||
|
sweet as and one more question ive got a vortech fmu and on the top of it is a fiting that says boost on it would that run in the vacum line or to the wastegate
|
||
| Top | |
||
| HiBoost |
|
||
|
Sik_Cordz wrote: sweet as and one more question ive got a vortech fmu and on the top of it is a fiting that says boost on it would that run in the vacum line or to the wastegate
Pretty sure into the vac line same place as the boost line
_________________ 4LTR-JET: 9.1 @150mph!! |
||
| Top | |
||
| EBXR8380 |
|
|||
|
I would have Map and Fuel reg on same outlet...So the tuning side is the same with no interferance..
Away from inlet ports as possible to prevent fluctuations, make better signal.... I would have guage seperate.....
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 16 guests |
