|
| tonyxd |
|
||
|
more powerful alternator
have fitted au thermo fans want fit ewp 115 with modulater to run both pump and fans. what do i need to do with the origional water pump? where do i get an altrnater thats going to keep some volts in my battery? |
||
| Top | |
||
| 66 coupe |
|
||
|
better off running the mech water pump, if its a street car.
Alternator wise, you can use a bosch BXU12121 which is a 120 amp unit, it will require a spacer on the top mount (or a handful of washers) |
||
| Top | |
||
| tonyxd |
|
||
|
why is evrybody so scared of elec water pumps? i would like to drive an alternator and an aircon compressor with out having v belts running all over the place.
thanks for the alternater info |
||
| Top | |
||
| XR9UTE |
|
||
|
"They're" not afraid of electric water pumps they are just more likely to fail therefore it's safer to use a belt driven pump. If I still had a cleveland powered car I'd finish the serpentine drive system I was working on and have reliable single belt system.
If don't want to do this there are some complete systems made in the U.S. where all the development work is done for you. It won't be cheap though...... http://www.marchperf.com/styletrack_clev.html |
||
| Top | |
||
| tonyxd |
|
||
|
well against all the best advice i'm still fitting an elec water pump!!!!
so please does any body know what i need to do with the origional pump, will it restrict water flow if left in place? |
||
| Top | |
||
| 66 coupe |
|
||
|
you will most likely need to take the impellor off as it will deflect the flow of water, thus restricting the flow somewhat, and maybe even the distribution between the left and right sides of the block., which means pressing the shaft out, and welding the nose of it closed - prob much easier with an ally pump rather than a cast one. or look at running a meziere pump instead, a bit more $ though.
You will also need to block the bypass hole in the block with an elec pump. |
||
| Top | |
||
| sooty72 |
|
|||
|
{USERNAME} wrote: well against all the best advice i'm still fitting an elec water pump!!!! so please does any body know what i need to do with the origional pump, will it restrict water flow if left in place? If your set on using a remote mount electric water pump, you should remove the standard water pump altogether and use a block off plate. You will need to plumb the water into it to get the water in and out of the block. Check out {DESCRIPTION} for there pumps and plates. They dont show it, but they do a plate for the 351C, to suit there SBF pumps. Not cheap though..... 
_________________ Yes, I own a Ute. No, I won't help you move! |
|||
| Top | |
|||
| tearlejc |
|
||
|
I was looking at the instructions for a Davies Craig elec pump - they said to leave the pump in place and it would just flow past it - I was sceptical then, still am...
_________________ 351 4V XB Coupe running LPG |
||
| Top | |
||
| tonyxd |
|
||
|
yes i think ill do the smart thing here and take the mech pump off and keep it just in case. i need a bit of aluminum welding practice so i might have a go at making my own inlet plate ect
thanks for the help |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 32 guests |
