|
FoX n LTD |
|
|||
|
was just wondering whats involved replacing the auto in my LTD,
it looks like a complicated job, exhuast and cats come very close, housing bolts look hard to get at, especially the top 2... replacement through a mech might cost over 1k, but i need it asap... don't know what to do :S |
|||
Top | |
EBXR8380 |
|
|||
|
Undo torque converter bolts, bellhousing bolts, drive shaft bolts, rear auto mount bolts..
Handbrake cable, maybe exhaust... T bar..Undo elect clips ... Place floor jack under auto and carefully remove.. Leave drive shaft in until you drain atf...
_________________ As in ZOOM 126 edition |
|||
Top | |
FoX n LTD |
|
|||
|
is it hard to do?
i've been told its difficult due to lack of room and hard to reach bolts at the top on the bell, i looked under and got the impression i was biting off more than i could chew, i've one multiple changes on the older falcons, they were piss easy |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 42 guests |