|
| xr8ute |
|
||
|
Bummer. You are going to want bigger injectors before you change to a larger cam.
The 24lb (on my AU XR8 at least) are 0 280 155 903. They pop up every now and then 2nd Hand for cheap. You would need to get a chip or a flash tuner to make them work though... |
||
| Top | |
||
| 67RCE |
|
||
|
I understand that BPT have the BBK SSI with the T/B on the "correct" side for the Falcon, anyone know how to do that?
_________________ ILL60 - EF XR8, Sunroof, Ticky Kit, 19x8.5/19x11 TE37's, 347, AFr185's, TFS BoxRcustom converter, Hurst Quarterstick, huge billet cam. |
||
| Top | |
||
| ovo616 |
|
|||
|
bbk ssi is reversible.
if you look at http://www.bbkperformance.com/products/ ... ifold.html their is a pic of just the lower half, I know thats not the intake your talking about but they use the same lower. |
|||
| Top | |
|||
| EBXR8380 |
|
|||
|
How long are the runners ??
How high is it ?? Will it fit under bonnet ??
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| 67RCE |
|
||
|
BPT have put one in an EB, so im assuming so
_________________ ILL60 - EF XR8, Sunroof, Ticky Kit, 19x8.5/19x11 TE37's, 347, AFr185's, TFS BoxRcustom converter, Hurst Quarterstick, huge billet cam. |
||
| Top | |
||
| BOTTLEDUP |
|
|||
|
{USERNAME} wrote: bbk ssi is reversible.
if you look at http://www.bbkperformance.com/products/ ... ifold.html their is a pic of just the lower half, I know thats not the intake your talking about but they use the same lower. That box unit doesn't look too bad, I'd want to see inside it though. Could be an alternative to the TFS R Box intake.
_________________ TE50 T1 P01 |
|||
| Top | |
|||
| EBXR8380 |
|
|||
|
Haha strange I mention TFS boxed before on another forum .. It was debated that the runers would be too short!! I'd say it would be good for stroker or well camed up engine ??
Both similar to TE50's inlets...
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| damianm79 |
|
||
|
This one I can answer for you...
The top half is reversible... you must leave the locating dowels out of the bottom half of the manifold when assembling.... the other problem is, the throttle body is back the front... ie you need to make up a custom bracket to pull on the acclerator linkage.... same for cruise control... I didn't use the EGR, but I made up a 2" alloy spacer in place to extend the throttle linkage past the top of the rocker cover... Otherwise all ok.. Cheers, Damian |
||
| Top | |
||
| BOTTLEDUP |
|
|||
|
Does anyone have pics of the inside of the 'box' section? I'm curious to see if it has the bellmouths and a volume similar to the T3 intake.
Even the T3 intake lacks torque below 3000 rpm compared to the Explorer intake.
_________________ TE50 T1 P01 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 13 guests |
