|
Pewthemagpie |
|
|||
|
Have come across a bit of a catch while stripping down my old clevo. How do you remove the cam bearings? Dont want to damage the block/bearing surface trying to get em out....
|
|||
Top | |
paulhowes |
|
|||
|
It's done with a drift. Take it to an engine rebuilder or some experienced mechanics will have a bearing tool and it wont take much or damage the pocket much to have them done.
WARNING- Not done right (lining up the oil feeds) will result in oil starvation and eventual failure. It costs three fifths of F**k all to have them done so pay the toll. |
|||
Top | |
Pewthemagpie |
|
|||
|
{USERNAME} wrote: It's done with a drift. Take it to an engine rebuilder or some experienced mechanics will have a bearing tool and it wont take much or damage the pocket much to have them done.
WARNING- Not done right (lining up the oil feeds) will result in oil starvation and eventual failure. It costs three fifths of F**k all to have them done so pay the toll. Cheers mate.. |
|||
Top | |
pinkbits8u |
|
|||
|
the amount of times ive paid for someone to put in the bearings $80 ( which are about 25$ for clevite ) i should have made up some dolleys myself ,
if your only going to do it every few years its best to get an engine builder to do it |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 28 guests |