|
| frog |
|
||
|
Engine has been sitting for a while with no oil in it. Thinking it would be a good idea to clean it out as I've had the valley cover off and although I plugged all the holes I'm sure bits of gasket will get in the motor. Motor also had a little water get in which I why I dumped the oil. Was thinking on filling up with kero and sitting for an hour then dumping it and fresh oil. Any thoughts?
|
||
| Top | |
||
| Mad2 |
|
|||
|
talking an 8?
|
|||
| Top | |
|||
| TROYMAN |
|
||
|
{USERNAME} wrote: talking an 8? well it is in the v8 workshop... it will be ok, 5 litres or so of kerro to flush the sump wont hurt. |
||
| Top | |
||
| Mad2 |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: talking an 8? well it is in the v8 workshop... it will be ok, 5 litres or so of kerro to flush the sump wont hurt. errr ummm ..... yeah  v8 i bought a few years ago got sump/heads pulled of & washed down n put back tagether [crank/bearings were left alone] but i didnt use any kerro [some spray can stuff???] then primed block before starting [oil] |
|||
| Top | |
|||
| frog |
|
||
|
Cheers, yes it's an 8.
|
||
| Top | |
||
| SWC |
|
||
|
{USERNAME} wrote: talking an 8? Last time I looked, I6 doesn't have a valley cover. |
||
| Top | |
||
| cjh |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: talking an 8? Last time I looked, I6 doesn't have a valley cover. Valley covers are found on big block Pontiac V8's.....Intake Manifolds sometimes contain an integral valley cover....like a highrise 'spider' looking intake. Anyway, filling the engine to the rocker covers won't hurt it, and you could leave it sit for a week....won't hurt it.......drain it, put some cheap oil ( Castrol GTX or similar ) in it, a filter, run it, don't drive, on a high idle of about 1,500 rpm for about 20 minutes, drain while hot, fill with desired oil, change filter, and go from there.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| Mad2 |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: talking an 8? Last time I looked, I6 doesn't have a valley cover. so ya sayin ya 8 does?? .... where? |
|||
| Top | |
|||
| frog |
|
||
|
Between the heads I'm guessing. Only a guess though, no need to get uptight.
|
||
| Top | |
||
| TROYMAN |
|
||
|
{USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: talking an 8? Last time I looked, I6 doesn't have a valley cover. so ya sayin ya 8 does?? .... where? well technically the intake manifold is the valley cover on the v8.. 
|
||
| Top | |
||
| Mad2 |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: talking an 8? Last time I looked, I6 doesn't have a valley cover. so ya sayin ya 8 does?? .... where? well technically the intake manifold is the valley cover on the v8.. back
|
|||
| Top | |
|||
| Lowlane7 |
|
||
|
{USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: talking an 8?  Last time I looked, I6 doesn't have a valley cover.  so ya sayin ya 8 does?? .... where?  (wtf?)well technically the intake manifold is the valley cover on the v8.. backROFPMSL 
_________________ [color=#004080]Cheers, Jacob. |
||
| Top | |
||
| Mad2 |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: Last time I looked, I6 doesn't have a valley cover. so ya sayin ya 8 does?? .... where? (wtf?)well technically the intake manifold is the valley cover on the v8.. backROFPMSL [/quote]glad SOMEONE finally saw the funny side 
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 59 guests |
