|
| revhead |
|
||
|
Nice looking el, not sure about your starting problems but fuel economy depends on how the car is driven. I have a 5.0Lt ef which was moded before I got it, and have to admit I'm happy with fuel use. I dont baby the car but dont flog it either and get 15lt/100km town and 10.4lt/100hwy. I find better fuel economy cruising at 120 rather than sitting at 100km's. A few people I know that were die hard holden fans have crossed the line and wont go back enjoy your new ride.
_________________ ef fairmont ghia 5.0L
|
||
| Top | |
||
| Scaffy |
|
|||
|
I give mine plenty of s**t and it uses around 12.5 - 13.5l/100km around town. Probably running lean tho~
_________________ Trickflow Street Heat top end kit, 70mm BBK TB & EGR, 24lb injectors, Underdrives & 3.73s: 275rwhp - 13.15@105mph NA / 12.37@116mph N20 |
|||
| Top | |
|||
| XH5LWEPN |
|
|||
|
{USERNAME} wrote: I give mine plenty of s**t and it uses around 12.5 - 13.5l/100km around town. Probably running lean tho~
Shouldnt be running lean after the TwEECer mate, if it is thats a waste of money fitting the TwEECer aint it. Get it on a dyno if ya not sure.
_________________ STREETBUILT RACING |
|||
| Top | |
|||
| Scaffy |
|
|||
|
Yeah, I was going to, but I'm time poor at the moment and when I get the top end rebuilt it'll get done then. Unfortunately the EEC I'm using isn't 100% compatible and if I want to change anything in the tune, everything has to be wiped and fully tuned again.
_________________ Trickflow Street Heat top end kit, 70mm BBK TB & EGR, 24lb injectors, Underdrives & 3.73s: 275rwhp - 13.15@105mph NA / 12.37@116mph N20 |
|||
| Top | |
|||
| Damo |
|
|||
|
expect to pay between $500-$800 for explorer manifolds, upper and lower. I think that mod alone would see a great improvement in performance with your car.
I always thought it had a hi-stall already, or did nick ditch it when he swapped the auto ? |
|||
| Top | |
|||
| [HMASEL] |
|
|||
|
The stall shat itself when the auto went apparently.
|
|||
| Top | |
|||
| [HMASEL] |
|
|||
|
$650 for just the AU 5ltr manifold, no T/B..
Reasonable price? |
|||
| Top | |
|||
| XH5LWEPN |
|
|||
|
{USERNAME} wrote: $650 for just the AU 5ltr manifold, no T/B..
Reasonable price? Bit on the top end of what you'd wanna pay. Have look around you should be able to pick one up for $500. Just remember if you get one of an AU you'll have to drill and tap the IAT sensor hole into runner 5 (i think), but if you get one from an ELII or XHII they have the IAT sensor already in the manifold. This is due to the AU's having the sensor relocated into the rubber air intake pipe.
_________________ STREETBUILT RACING |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |
