Hi everyone, I really need to know abot the cross-member and will a clevo fit in ith the same cross-member, Or if it wont which will fit.
And a side note, Any cam suggestions for running gas in the clevo?Thanks in advance for all your help!

You will need the V8 bracket that bolt onto the cross-member as they are totally different to 6 cylinder. I know that XA V8 onwards brackets bolt onto all models from XA to XF, pre XA I am unsure about, bad memory.

As for gearbox cross-member it depends on which transmission you will be using, most of them swap and can bolt onto different locations if needed.
From poor memory XA-XD cross-members are the same, XE-XF are smaller different ones.

prety sure need to change eng loom too,accelerator cable,trans lines,say bye if it had workin air con as compressor sits diff spot,exhaust thats diff too, i did engine swap on a zj fairlane i used complete cars to swap all the parts made it easier.
all your rad hoses are diff,