|
| AXR88U |
|
|||
|
Just a quick question to ease my curiosity.
Does the AU intake manifold have the hole tapped into the intake runner same as the HO manifold for the intake air temperature sensor 
If not, have people been drilling and tapping the manifolds to suit, or relocating the intake air temperature sensor to somewhere else ??
_________________ ________________________________________
|
|||
| Top | |
|||
| TerroristGHIA |
|
|||
|
It is usually relocated to the intake pipe, as per the AU's. Cause the AU intake manifold doesnt have this provision.
Brett
_________________ The Terrorist ED Retired due to RUST. |
|||
| Top | |
|||
| EDXR8 |
|
|||
|
Yeah exactly just install it in the intake pipe or even easier in the airbox.
|
|||
| Top | |
|||
| AXR88U |
|
|||
|
Sounds easy enough, would just involve extending the wires to reach hey.
_________________ ________________________________________
|
|||
| Top | |
|||
| TerroristGHIA |
|
|||
|
Thats it. What are you up to on the weekend, Drop over to Joes and check out the 5.0, if you are up for it
Brett
_________________ The Terrorist ED Retired due to RUST. |
|||
| Top | |
|||
| Samantha |
|
||
|
Have also seen these tapped into the upper manifold, toward the front underside of the plenum - I think there's already a posi for a fitting there.
|
||
| Top | |
||
| AXR88U |
|
|||
|
Joe rang me the other day with some questions about getting some turbo's passed.
Asked him about what your up. Might of gave him a fix on getting a convertor box to fix your speedo problem. Only side affect of that is it may rev a couple of hundred rpm or so before shifting. Not that thats a problem though, I reckon they shift too early anyway. If I have a bit of time I will pop around, but I've got a bit of work on at the moment, so I cant promise anything.
_________________ ________________________________________
|
|||
| Top | |
|||
| AXR88U |
|
|||
|
{USERNAME} wrote: Have also seen these tapped into the upper manifold, toward the front underside of the plenum - I think there's already a posi for a fitting there.
Is that using one of the PCV holes ? Not a bad idea
_________________ ________________________________________
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 35 guests |
