|
Bsjenko |
|
|||
|
I have just acquired a 72mm Maf, but there was no plug input or hotwire on it. so just the maf caseing.
Can i use my original plug and hotwires in this Maf? cheers BEN
_________________ The Lane Lives.... Finally!!!! |
|||
Top | |
WARMACHINE |
|
||
|
Yes just bolt the maf with sensor into the housing.
|
||
Top | |
Timmeh |
|
||
|
I would then put it on a dyno and make sure the air/fuel ratio is good.
|
||
Top | |
Bsjenko |
|
|||
|
cheers raptor, thats all i needed to know
yeah timmeh, it shall be going on dyno once a few other bots and pieces are added. There shall be a thread in the Garage section soon
_________________ The Lane Lives.... Finally!!!! |
|||
Top | |
xr8ute |
|
||
|
72mm? Where is the housing from?
|
||
Top | |
Bsjenko |
|
|||
|
I dont know the exact measurement. i measured it while p****d the other night with a old ruler i had lying around.
It is a ford housing, off the au's. could be 73mm, i dunno
_________________ The Lane Lives.... Finally!!!! |
|||
Top | |
xr8ute |
|
||
|
Probably a 70mm from an AU. Is it plastic or aluminium?
You need to measure from the narrowest point which is not at either end, but somewhere in the middle. |
||
Top | |
willsace |
|
|||
|
yeah its a 70mm au maf. he bought it off me
|
|||
Top | |
Bsjenko |
|
|||
|
aluminium. yea prob sounds about right. i dunno its a hell of a lot bigger than what i had.
pretty sure its calibrated for 24lb injectors too, i think.
_________________ The Lane Lives.... Finally!!!! |
|||
Top | |
xr8ute |
|
||
|
{USERNAME} wrote: pretty sure its calibrated for 24lb injectors too, i think.
OEM MAF's are not calibrated for any injector size. Do a search if your not sure what I mean... Run the electronics from your 55mm MAF if you like. |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 47 guests |