|
| Sipheren |
|
|||
|
Hi Guys,
I have noticed a strange issue with my ED, when I give it a boot it will make a rattle sound under load at around 3000 - 5000rpm. It doesn't do it when there is no load. About a year ago I changed the spark plugs, coil and leads changed, fitted a new dizzy cover and had the fuel system pressure checked and fuel rail cleaned as well as the timing corrected. So I am unsure if this would pinging or something else... Any help would be great. Cheers |
|||
| Top | |
|||
| Matt_jew |
|
||
|
If it was a year ago it would be due new plugs.
Should change the fuel filter too.
_________________ {USERNAME} wrote: More people paid for a ride in a VT commodore then an AU Falcon so the VT is superior.
Based on that fact my Mum is the best around! |
||
| Top | |
||
| Sipheren |
|
|||
|
Yeah? I thought plugs lasted for a few years...
I will give them a change over the weekend and see if it helps. Cheers |
|||
| Top | |
|||
| xafalcon |
|
||
|
Check balancer hub is still firmly bonded to inner section first. Then check base timing in diagnostic mode is set to 30 BTDC.
_________________ XA Faimont 351C, AU2 XR8 Manual 5.0, DA LTD 5.0, Mk1 Capri 5.0, 1995 Mustang 5.0, EF2 XR8 Manual, EF2 Fairmont Ghia 5.0, AU3 XR8 Auto, AU2 XR8 Auto, AU2 XR8 Manual Ute, TE Cortina 5.0 Manual, DU LTD 5.0 soon to be manual |
||
| Top | |
||
| Sipheren |
|
|||
|
|
|||
| Top | |
|||
| blueblood |
|
|||
|
Mine pings on 91ron, no issues with 95-98 or 100ron though.
_________________ 93 EB S-XR8 5 SPEED, |
|||
| Top | |
|||
| Sipheren |
|
|||
|
{USERNAME} wrote: Mine pings on 91ron, no issues with 95-98 or 100ron though. Yeah, I only use 95, pings with 91. |
|||
| Top | |
|||
| xafalcon |
|
||
|
They are designed to run on 89 RON, so if you're pinging on 91 there is something wrong. Over-advanced timing does not help power, economy or engine life
_________________ XA Faimont 351C, AU2 XR8 Manual 5.0, DA LTD 5.0, Mk1 Capri 5.0, 1995 Mustang 5.0, EF2 XR8 Manual, EF2 Fairmont Ghia 5.0, AU3 XR8 Auto, AU2 XR8 Auto, AU2 XR8 Manual Ute, TE Cortina 5.0 Manual, DU LTD 5.0 soon to be manual |
||
| Top | |
||
| Sipheren |
|
|||
|
{USERNAME} wrote: They are designed to run on 89 RON, so if you're pinging on 91 there is something wrong. Over-advanced timing does not help power, economy or engine life As far as I know the timing is correct. I don't have a timing light so I had to get a mechanic do that. |
|||
| Top | |
|||
| blueblood |
|
|||
|
{USERNAME} wrote: They are designed to run on 89 RON, so if you're pinging on 91 there is something wrong. Over-advanced timing does not help power, economy or engine life Yep, but thats U.S 89ron which is apparently more like 91ron, with U.S 91ron actually sold as premium! I think mine pings on 91 as a result of the AU maf and throttle body leaning it out. I also found with my old ED, just the odd tank of 98 would stop it pinging on 91.
_________________ 93 EB S-XR8 5 SPEED, |
|||
| Top | |
|||
| xafalcon |
|
||
|
{USERNAME} wrote: {USERNAME} wrote: They are designed to run on 89 RON, so if you're pinging on 91 there is something wrong. Over-advanced timing does not help power, economy or engine life Yep, but thats U.S 89ron which is apparently more like 91ron, with U.S 91ron actually sold as premium! I think mine pings on 91 as a result of the AU maf and throttle body leaning it out. I also found with my old ED, just the odd tank of 98 would stop it pinging on 91. RON is RON regardless of country, it is a laboratory measurement on a knock engine under defined conditions. US does not use RON, it uses (RON+MON)/2. An AU MAF (or parts thereof) on an unmodified E-series ecu is generally a poor combination that can run both lean & rich at different areas in the airflow measurement range. eg With an AU MAF housing & sensor I have measured as rich as 10:1 under moderate (not even WOT) acceleration above 3500RPM. That's 2.5 points off the maxiumum power 12.5-12.8 sweet spot for the SBF, so powder is being lost as well as excessive fuel consumption. A factory E-series MAF will run at or slightly above 12:1 under the same conditions, so much closer
_________________ XA Faimont 351C, AU2 XR8 Manual 5.0, DA LTD 5.0, Mk1 Capri 5.0, 1995 Mustang 5.0, EF2 XR8 Manual, EF2 Fairmont Ghia 5.0, AU3 XR8 Auto, AU2 XR8 Auto, AU2 XR8 Manual Ute, TE Cortina 5.0 Manual, DU LTD 5.0 soon to be manual |
||
| Top | |
||
| Landau510 |
|
||
|
I would give your MAF a clean first....10 bucks for a can of MAF cleaner and 10 minutes works sorted the pinging in my DL...it was doing the same as what yours is doing.
_________________ Lets just pretend I give a s**t and leave it at that..... |
||
| Top | |
||
| Sipheren |
|
|||
|
{USERNAME} wrote: I would give your MAF a clean first....10 bucks for a can of MAF cleaner and 10 minutes works sorted the pinging in my DL...it was doing the same as what yours is doing. MAF cleaner? Is that the same as Carby cleaner? |
|||
| Top | |
|||
| blueblood |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: {USERNAME} wrote: They are designed to run on 89 RON, so if you're pinging on 91 there is something wrong. Over-advanced timing does not help power, economy or engine life Yep, but thats U.S 89ron which is apparently more like 91ron, with U.S 91ron actually sold as premium! I think mine pings on 91 as a result of the AU maf and throttle body leaning it out. I also found with my old ED, just the odd tank of 98 would stop it pinging on 91. RON is RON regardless of country, it is a laboratory measurement on a knock engine under defined conditions. US does not use RON, it uses (RON+MON)/2. An AU MAF (or parts thereof) on an unmodified E-series ecu is generally a poor combination that can run both lean & rich at different areas in the airflow measurement range. eg With an AU MAF housing & sensor I have measured as rich as 10:1 under moderate (not even WOT) acceleration above 3500RPM. That's 2.5 points off the maxiumum power 12.5-12.8 sweet spot for the SBF, so powder is being lost as well as excessive fuel consumption. A factory E-series MAF will run at or slightly above 12:1 under the same conditions, so much closer On an unmodded 5.0 I'd agree, I've recently fitted ELGT extractors and high flow cats and they, in combination with the duel exhaust, AU maf, 65mm throttle body and 2nd airbox entry, seem to have hit a sweet spot in the tune (or lack there of). I can only imagine how much more I could get with a j3 tune.
_________________ 93 EB S-XR8 5 SPEED, |
|||
| Top | |
|||
| blueblood |
|
|||
|
{USERNAME} wrote: eg With an AU MAF housing & sensor I have measured as rich as 10:1 under moderate (not even WOT) acceleration above 3500RPM. I havnt seen the AU sensor and loom but was, for some reason, under the imression they had different wiring or something? So I just use my EB sensor in the AU housing. When I eventually get a J3 tune should I use the EB sensor or an AU one?
_________________ 93 EB S-XR8 5 SPEED, |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 27 guests |
