|
toddy |
|
|||
|
i have a 351 cleveo in my fairlane
not long after taking the two barrel off and putting a four barrel on it started to burn oil my wife can drive it and not use any oil but when i drive it iuse heaps are my rings f**k or did i do something wrong when putting on the four barrel?
_________________ Turbo....bigger, badder......more....more........more |
|||
Top | |
toddy |
|
|||
|
anyone
_________________ Turbo....bigger, badder......more....more........more |
|||
Top | |
The Dog |
|
|||
|
I held off for as long as I could mate.......................stop thrashing it! Won't burn oil anymore (and Boofhead up the road will stop whinging about the noise that must be you cos I am a quiet clean living kinda guy)
Sorry as usual got nothing constructive to say!
_________________ You'll ride a black tornado across the western sky
|
|||
Top | |
Walker |
|
|||
|
It was only 52 minutes between your first and second post mate, relax lol.
Is it going through heaps of fuel? If an engine is dumping too much fuel in it can wash the oil from the bores and wear the rings down at a rapid rate... Have seen this happen a few times. What kind of carb are you running on it? |
|||
Top | |
toddy |
|
|||
|
runs real cheap it on da gas
_________________ Turbo....bigger, badder......more....more........more |
|||
Top | |
The Dog |
|
|||
|
Alright I'll be serious. Do you think it is possible that the inlet manifold gaskets are leaking under high vacuum ie. when toddy is driving (thrashing!) it? This would allow it to suck oil in from under the valley cover, no?
_________________ You'll ride a black tornado across the western sky
|
|||
Top | |
The Dog |
|
|||
|
Casey reckons I am right Pete!!!
_________________ You'll ride a black tornado across the western sky
|
|||
Top | |
Walker |
|
|||
|
{USERNAME} wrote: Alright I'll be serious. Do you think it is possible that the inlet manifold gaskets are leaking under high vacuum ie. when toddy is driving (thrashing!) it? This would allow it to suck oil in from under the valley cover, no?
Yep, that was going to be my next comment... Definately not uncommon for that to happen. Did you use any type of sealer around the gaskets? I recommend a bead of silicone on the ends, and Permatex No3 along the face of the ports on head and intake. It sounds like you could be sucking oil into the ports from the valley. |
|||
Top | |
toddy |
|
|||
|
its all caseys fault
_________________ Turbo....bigger, badder......more....more........more |
|||
Top | |
Walker |
|
|||
|
Bordetown would have to be small wouldn't it? (Can't remember it, been a long time).
Do you know eachother lol? |
|||
Top | |
The Dog |
|
|||
|
Toddy lives straight across the road from me (and I was here first! )
_________________ You'll ride a black tornado across the western sky
|
|||
Top | |
toddy |
|
|||
|
bordertown is small we live across the road from each other
_________________ Turbo....bigger, badder......more....more........more |
|||
Top | |
TROYMAN |
|
||
|
If its on lpg and its blowing smoke (burning oil) i would say your rings are definatly gone!! if you think its burning oil now try running it on petrol and it will blow more smoke and burn more oil !!!
i use to have a old v8 valiant on gas and the rings were worn out. it would only burn oil when you give it a thrashing but when i switched it over to petrol it was one nasty smoke machine... i was using about 4ltrs of oil every 400 kms!! but it just kept on going and going and going.... all i can say is dont thrash it as much or just keep topping the oil up or you can reco it.. |
||
Top | |
Walker |
|
|||
|
Try Ajax, that was an old Diesel trick lol.
|
|||
Top | |
toddy |
|
|||
|
just done a compression test mostly around 110 psi
so that sound a bit low to me?
_________________ Turbo....bigger, badder......more....more........more |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 41 guests |