|
| Memphis` |
|
||
|
Hey everyone,
I have an EF XR8 and I've just had to replace my starter motor because it was completely burnt out. This is because of the position of the starter motor being too close to my new extractors. I'm assuming it's just getting too hot down there for it. To stop a repeat of this happening again, my mechanic suggested getting some sort of heat shield or fibreglass installed. Does anyone know somewhere in Perth I could get this done? and roughly how much I'd be looking at paying? Thanks a lot in advance. Adam
_________________ RARRELL |
||
| Top | |
||
| Disco Frank |
|
|||
|
hey dude fibreglass would more than likely burn or melt
i would suggest a metal heatsheild of some sort over the starter motor u just need a small air gape ie 1-2cms to help prevent the heat gettign in or for a cheaper way get some exhaust wrap and wrap the pipes just near the starter motor or for more $$ full ceramic coatin
_________________ RIP SCOTT |
|||
| Top | |
|||
| schnoods |
|
|||
|
Go to an exhaust shop near you as they have alot of heat shield material.
_________________ Because of Beer, Thirst is a Beautiful Thing! |
|||
| Top | |
|||
| Froudey |
|
||
|
hunt around at the wreckers for an NF or NL sheild as they have a small heat shield on the starter motoer...
_________________ R.I.P Tobias my son. |
||
| Top | |
||
| XH5LWEPN |
|
|||
|
Yeah mine had an original heat sheild on it. Obviously from factory, so yeah search around a few wreckers, they should have one for sure.
_________________ STREETBUILT RACING |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
{USERNAME} wrote: hunt around at the wreckers for an NF or NL sheild as they have a small heat shield on the starter motoer...
really thats kinda cool
_________________ RIP SCOTT |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 17 guests |
