|
| Riceburner |
|
||
|
Hi I have a au 3 v8 and doing a conversion but have found the t5 box 20mm short at the shifter the xr6 box I have is the correct length but bell housing and input wrong, the difference in the length is the tail housing does anyone know the correct length of the au box
Cheers |
||
| Top | |
||
| Mad2 |
|
|||
|
correct from where to where?
|
|||
| Top | |
|||
| Riceburner |
|
||
|
Total length would be good and from front Bell housing to shifter
|
||
| Top | |
||
| Riceburner |
|
||
|
Total length would be good and from front Bell housing to shifter
|
||
| Top | |
||
| Mad2 |
|
|||
|
can't give you total length as i don't have a V8 bellhousing. can give you the 6 cylinder input length & length of box from front of box to centre of shifter, again 6 cylinder.
|
|||
| Top | |
|||
| Riceburner |
|
||
|
Cheers in saying that they should be the same as I have an xr6 box and so called a au v8 box bell housing and input shaft is different but problem is tail shaft and shifter doesn’t line up with floor hole and I’m not sure if hole in gllor is different from auto to manual , I have noticed press mark in floor but again not sure and seems to be hard to find out
|
||
| Top | |
||
| Mad2 |
|
|||
|
{USERNAME} wrote: Cheers in saying that they should be the same as I have an xr6 box and so called a au v8 box bell housing and input shaft is different but problem is tail shaft and shifter doesn’t line up with floor hole and I’m not sure if hole in gllor is different from auto to manual , I have noticed press mark in floor but again not sure and seems to be hard to find out the AU 6 & 8 use the same box housing [i believe] with the tail shaft being shorter for the manual. the EA to EL used a shorter rear housing of about 2 inches. |
|||
| Top | |
|||
| Riceburner |
|
||
|
I think you are correct the box v8 one is 2 inches shorter. And now I would say from el or alike the bell housing is correct but that is bolt on , the shifter should come straight up for au ? At the moment would have to be dog legged
Thanks for your help |
||
| Top | |
||
| Riceburner |
|
||
|
So is there a difference between the 6 and 8 t5 box the t5 xr6 box would fit perfectly the input shaft is the same as the so call v8 box but if I changed the bell housing it should fit but unsure of what affect it will have ?
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 37 guests |
