|
| Bradelz77 |
|
||
|
hey guys just wondering if an XF 3spd manual column shift will bolt to ea to el 6 cylinder,
|
||
| Top | |
||
| blu857 |
|
|||
|
no box will not just bolt straight up as starter motor is on wrong side . not sure though if you can get a 5speed bell housing from an e series n redrill the box to bell housing bolt patern
|
|||
| Top | |
|||
| frd906n |
|
||
|
why bother when u can get a 5sp instead for chips for a eseries
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| Bradelz77 |
|
||
|
because i like the room i have with the column shift, nevermind, thanks guys
|
||
| Top | |
||
| OZBMX |
|
|||
|
hunt down a taxi(well any model with benchseat. lot of xh's had it), you could get the 4 spd column on them, although, I think bellhousing, handbrake, column shrouds linkages. not the easiest to do but can be done.
oh you want manual, I think you'll have a bit of trouble, as mentioned bellhouseing. etc. they only ever did column e serie in auto. be a fair bit f custom work to pull it off.
_________________ Signature removed by moderator.signature must not exceed 120x500 pixles |
|||
| Top | |
|||
| sooty72 |
|
|||
|
Go to http://www.rodshop.com.au/trans_conversions/2wd_trans.htm and scroll down the page to BH091A. That will solve the problem for you.
Good luck. 
_________________ Yes, I own a Ute. No, I won't help you move! |
|||
| Top | |
|||
| cjh |
|
|||
|
The 3sp spigot is smaller than the 5sp spigot too, as well as the spline is smaller, too.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| The Panel Van Man |
|
||
|
The guys from G.B Race cars made there own for a BA with 3 speed speedway car. But a T5 one should be able to be adapted & if u use an EA flywheel you should be able to get a clutch & pressure plate to fit. Regards TPVM.
_________________ SALT IS FOR RACING ON. SAUCE IS FOR FISH & CHIPS. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |
