|
| SLO247 |
|
||
|
FordFairmont wrote: http://www.injectorsonline.com/indivprod.php?cid=73&filter=FORD Thanks 
|
||
| Top | |
||
| 89S-PACK |
|
|||
|
was wondering if you knew what the ohm range the factory fuel tank sender uses in a 1992 eb sedan??
im trying to nut out how to make the lpg tank guage run off the dash guage thanks matt |
|||
| Top | |
|||
| arm79 |
|
|||
|
89S-PACK wrote: was wondering if you knew what the ohm range the factory fuel tank sender uses in a 1992 eb sedan?? im trying to nut out how to make the lpg tank guage run off the dash guage thanks matt 10 - 176 ohm. You can get LPG tank senders with the same resistance values and wire that in place of the fuel sender. |
|||
| Top | |
|||
| foggy |
|
||
|
Hi Papa Smurf,
Could you give me a part number and price on the transmission cooler thermastat for a BF egas ute and also if possible could you post a picture of the engine temp sensor. Thanks in advance Foggy |
||
| Top | |
||
| Papa Smurf |
|
||
|
foggy wrote: Hi Papa Smurf, Could you give me a part number and price on the transmission cooler thermastat for a BF egas ute and also if possible could you post a picture of the engine temp sensor. Thanks in advance Foggy Matey, I am not sure what you mean by Thermostat for Oil Cooler? Attachment: Hoses.JPG Here is a pic that might help and also the pic for the Temp Sender. Attachment: Sensor.JPG
|
||
| Top | |
||
| foggy |
|
||
|
In the pictures you have attached it is number 18495.
Thanks Foggy |
||
| Top | |
||
| Papa Smurf |
|
||
|
foggy wrote: In the pictures you have attached it is number 18495. Thanks Foggy That heater tap has been replaced by a pipe, the pic is below and it replaces 2 pipes in your system. The pipes it replaces are the 6N792 and 6N793. Part number BAF2 7H420 A $62.80 Attachment: DSCF0839.jpg
|
||
| Top | |
||
| foggy |
|
||
|
Thankyou for your help.
I will stop in to the shop and see you guys as it looks like I need to do some updating to my cooling system and trans cooler plumbing. From the pictures you attached I cant quite visualise the changes. See Ya, Foggy |
||
| Top | |
||
| 89S-PACK |
|
|||
|
arm79 wrote: 89S-PACK wrote: was wondering if you knew what the ohm range the factory fuel tank sender uses in a 1992 eb sedan?? im trying to nut out how to make the lpg tank guage run off the dash guage thanks matt 10 - 176 ohm. You can get LPG tank senders with the same resistance values and wire that in place of the fuel sender. thanks mate i'll have to get one. as im looking at just using a duel position relay to switch between both senders. |
|||
| Top | |
|||
| EDXR6-Poly |
|
|||
|
Hey Papa, any chance FORD still make a CAM ANGLE SENSOR for a EF fairmont I6 and price at all?
_________________ AU2 engine with Hoppers head/cam performance package & spool rods / CP pistons ,Snort 1200 plenum, T56 Manual & Billet short shifter, Front & Rear Slotted rotors, Pedders lowered suspension, LSD and tuned with EMS stinger 4424 347rwkw THE ED XR6 IS BOOSTED |
|||
| Top | |
|||
| Papa Smurf |
|
||
|
EDXR6-Poly wrote: Hey Papa, any chance FORD still make a CAM ANGLE SENSOR for a EF Fairmont I6 and price at all? I figured out what you meant by the post you made in the wanted section, Ford calls it a Synchronizer and they are not available anymore, only For AU and they are $95.00. |
||
| Top | |
||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
hey papa smurf
is there a tyre placard sticker that i can put on my EB so it says it has 16 or 17 inch wheels factory? like a EB GT or one EF/L XR6/8 cheers
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| Papa Smurf |
|
||
|
WILDEB wrote: hey papa smurf is there a tyre placard sticker that i can put on my EB so it says it has 16 or 17 inch wheels factory? like a EB GT or one EF/L XR6/8 cheers Matey, there is the GT one off an EL, part number GTTVE 1532 A $11.80. Jefferson Ford is showing 1 and Ford Mtr Co has 20. George
|
||
| Top | |
||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
Papa Smurf wrote: WILDEB wrote: hey papa smurf is there a tyre placard sticker that i can put on my EB so it says it has 16 or 17 inch wheels factory? like a EB GT or one EF/L XR6/8 cheers Matey, there is the GT one off an EL, part number GTTVE 1532 A $11.80. Jefferson Ford is showing 1 and Ford Mtr Co has 20. George does it say EL model anywhere on it? and what wheel/tyre size is it?
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| Papa Smurf |
|
||
|
WILDEB wrote: does it say EL model anywhere on it? and what wheel/tyre size is it? I dare say it would have the original Service part number on it but I don't think it will specifically have EL written on it and AFAIK, 17x8.5 wheel size, pretty sure 235/45/17 |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 3 guests |
