|
| twr7cx |
|
|||
|
twason wrote: twr7cx wrote: can't wait to get my donk back from Joe and see how it goes with the VCT. Taking a while is it not?Yeah he's been busy and I won't have time until end of year uni exams finish to install it anyhow, so I havn't pushed for it yet. |
|||
| Top | |
|||
| twr7cx |
|
|||
|
Rick's EF Fairmont Wagon wrote: AFAIK the EF is wired up to suit and the AU having the same coil pack should be very close to an ECU swap.
I just need the full Engine loom diagrams for both and I can start experimenting. In fact since I have a spare EF car. I have the loom to work on. I might have to get a loom from and AU and just fit that instead? It'd definately be nice to get the AU ECU running in EF's without too much effort. |
|||
| Top | |
|||
| lowfo |
|
||
|
where did u hook up the oil line for the vct too if u did at all .....
|
||
| Top | |
||
| twase |
|
|||
|
A banjo adapter is used to connect it inline with the oil pressure sensor on the side of the block under the inlet manifold.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| frd906n |
|
||
|
 My question time  My mech just bought a series 1 manual au xr6 98 september build, its a wrecker, prang on the side Its a 5 spd manual + VCT My car is a 99 feb build forte, standerd i6 I wanna no if i can run the vct engine in mine but use my origanal ecu and run wires to activate the vct, 
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| twase |
|
|||
|
If you have the wreck then put the ECU and loom in from the donar.
Both seem to be smartlock and not smartshield so the makes life easier for you to do this.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| lowfo |
|
||
|
so will the vct head bolt straight up to a ef block and run with the coil pack set up and im going to use the ef intake and ef sensors just the vct head but running in non vct will it work ???
|
||
| Top | |
||
| TROYMAN |
|
||
|
lowfo wrote: so will the vct head bolt straight up to a ef block and run with the coil pack set up and im going to use the ef intake and ef sensors just the vct head but running in non vct will it work ??? yes it will... you wont get the full advantage without the vct but it will bolt on and run fine.. |
||
| Top | |
||
| lowfo |
|
||
|
cheers mate just picked up a vct head from a wrecker for 500 with intake ....... is that cheap ??
|
||
| Top | |
||
| TROYMAN |
|
||
|
not what i call cheap, but depends on the availability of them..
if there are not alot in your area you will pay a bit more.. i picked up my complete au vct engine for $600 with 100,000km.. |
||
| Top | |
||
| lowfo |
|
||
|
yeah hard to find but its only done about 1000km
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 5 guests |
