|
| Shortshift |
|
|||||
|
I bought Billet PRO 5.0 shifter for a T5 gearbox recently and noticed that there's nothing to seal the mechanism against dust & moisture. The standard shifter, it's replacing, has a rubber seal.
Can anyone tell me if there is a rubber cover, or something similar, available to seal the shifter? I've been searching the net (& Fordmods) but found nothing.
_________________ AU2 XR8 with Raptor VL, ported Yella Terra GT40P heads, Scorpion 1.6 RRs, XE264HR-14 Comp Cam, ceramic coated Hurricane Headers, 60lb injectors, Walbro 255, 200cfi cats, 3" exhaust & Snow Performance water methanol injection Last edited by Shortshift on Fri Mar 20, 2009 3:36 pm, edited 1 time in total. |
|||||
| Top | |
|||||
| krisisdog |
|
|||
|
Do you mean around the shifter mech at the bottom, or between the shifter and the box?
Perhaps a pic with the area you mean outlined might be of assistance? |
|||
| Top | |
|||
| MAD |
|
|||
|
I think you would be able to use this one.
http://mgwltd.com/mustang_shifter_inner_dust_boot.shtml I dont know of any others. Unless maybe you could take the one off your stock shifter. |
|||
| Top | |
|||
| Shortshift |
|
|||
|
Thanks MADXF. That's the part I'm after. The rubber seal on the standard shifter is not wide enough in diameter. I was looking at the Commodore seals, but they're not suitable either.
It would be handy if I can find someone in Oz that sell them as a lot of these websites have e-mail links but never reply to messages.
_________________ AU2 XR8 with Raptor VL, ported Yella Terra GT40P heads, Scorpion 1.6 RRs, XE264HR-14 Comp Cam, ceramic coated Hurricane Headers, 60lb injectors, Walbro 255, 200cfi cats, 3" exhaust & Snow Performance water methanol injection |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 143 guests |
