|
| Mad2 |
|
|||
|
Disco Frank wrote: did not ford actually have a part made that u could buy to fix this issue? i would plate both the inside and outside of the firewall! i used a thicker piece of flat [5mm ? ] on the outside which helps ta spread the load over a larger area & doesn't "flex" like the flimsy firewall plus i didn't have to remove anything as the firewall padding had fallen off - eventually had to do the usual repairs to the clutch pedal pin also the EA/EB possibly ED need reinforcing at the clutch pedal bracket - dunno about the lata models..... so check the pin area fa metal fatigue 
|
|||
| Top | |
|||
| evxr6 |
|
|||
|
3mm is enough. You can see the reinforcement plate I made to TROYMAN's design. The photos aren't on the tech doco any more. Click this and scroll down a bit http://www.fordmods.com/the-garage-f53/ev-s-xr6-5-speed-t99478-300.html
Link to tech doco: http://www.fordmods.com/firewall-re-enforcment-plate-manual-e-series-t66746.html
_________________ Current ride: MY03 Liberty RX Wagon |
|||
| Top | |
|||
| dat111 |
|
||
|
mines actually an AU its been like how it is for the past 8 months so maybe it has been repaired.. i have no idea!!
|
||
| Top | |
||
| evxr6 |
|
|||
|
Would be pretty much the same idea though, with some slight changes I would imagine.
_________________ Current ride: MY03 Liberty RX Wagon |
|||
| Top | |
|||
| dat111 |
|
||
|
so you reckon its been done?
|
||
| Top | |
||
| Mad2 |
|
|||
|
dat111 wrote: so you reckon its been done? yeah its not that hard ta do .... even if it is an AU
|
|||
| Top | |
|||
| TROYMAN |
|
||
|
evxr6 wrote: 3mm is enough. You can see the reinforcement plate I made to TROYMAN's design. The photos aren't on the tech doco any more. Click this and scroll down a bit http://www.fordmods.com/the-garage-f53/ev-s-xr6-5-speed-t99478-300.html Link to tech doco: http://www.fordmods.com/firewall-re-enforcment-plate-manual-e-series-t66746.html the thread has been edited and pics have been restored. the plate will fit au it just needs about 20mm cut off the left side of the plate.. im actually using the original plate from the doco on my last 3 cars and now fitted to my au xr8. |
||
| Top | |
||
| Lowlane7 |
|
||
|
If the piece on the outside of the firewall is welded on it might be fun trying to remove it. Have a look at above mentioned thread, and get a plate made up. I had similar problems with mine cracking and then the pedal box bending not long after.
Some pics are on my build thread of how I got mine made and how I fitted it. This will be the easiest fix... if the already done repairs are easy enough to remove...
_________________ [color=#004080]Cheers, Jacob. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 104 guests |
