|
| sickd |
|
|||
|
do the AU2 and AU3 calipers fit AU1 with out modification
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| xpression |
|
|||
|
in short, no, the disks and i believe the uprights are different
|
|||
| Top | |
|||
| sickd |
|
|||
|
so they are same as ef el?
do au1 have bigger brakes than ef el
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| Disco Frank |
|
|||
|
{USERNAME} wrote: so they are same as ef el?
do au1 have bigger brakes than ef el the calipers are the same as ef/el discs are different to fit au2/3 brakes on au 1 u need the uprights/lower control arms claipers/discs/ anti roll bar
_________________ RIP SCOTT |
|||
| Top | |
|||
| sickd |
|
|||
|
have you done this disco, so the upright (spindle (what the caliper bolts to) ) wont bolt to the upper and lower control arms of the au1 ?
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| xpression |
|
|||
|
i dont believe it does no...
|
|||
| Top | |
|||
| xr8 dismantler |
|
|||
|
we sell a few of these kits from BA's
you will need lower control arms uprights / spindles rotors calipers sway bar and sway bar mounts can do the set up for $1250 this is for 300mm ba stuff |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
{USERNAME} wrote: have you done this disco, so the upright (spindle (what the caliper bolts to) ) wont bolt to the upper and lower control arms of the au1 ?
no it dont fit i did want to do this as the au1 xr's brakes suck balls but since i am selling the car
_________________ RIP SCOTT |
|||
| Top | |
|||
| sickd |
|
|||
|
{USERNAME} wrote: we sell a few of these kits from BA's
you will need lower control arms uprights / spindles rotors calipers sway bar and sway bar mounts can do the set up for $1250 this is for 300mm ba stuff so would the au front end (lower control arm uprights shocks kframe ) all suspension parts bolt to a ef so then i could do this brake mod and in turn have AU offset
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| Fiox |
|
||
|
Guys, how owuld you install the rear mounting bushes of the series II/II or even BA to a series I. I beleive they are missing the mounting block in the chassis. Is this correct?
|
||
| Top | |
||
| colin55 |
|
||
|
I am looking at doing this and I am about to get some bf front suspension and I have looked at it all, and I would like to know, how do you attach the sway bar mounts as the au1 chassis is missing 2 holes on each side of the chassis for the bracket to bolt on to. will the au2/3/ba/bf sway bar fit in the existing mounts?
The only other this I thought of is drilling 4 holes, but I dont really want to do that. |
||
| Top | |
||
| colin55 |
|
||
|
if I were to get the 'kit' from the BA with all the front suspension etc... are the ABS sensors the same? if yes then no worries.
cheers |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 33 guests |
