|
| madeaspack |
|
||
|
i want to change from manual to auto,with a beefed up auto to handle the boost...will i need to change any wiring looms other than the trans loom?or do i need a new ecu-engine bay loom to plug the auto's loom into?
cheers
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| Nicko |
|
|||
|
you will need to change engine loom to auto, its a one piece loom. Not too hard to do.
If yours was ef all you would have to do is change the trans loom, but el they made it part of the endgine bay loom.
_________________ Nicko |
|||
| Top | |
|||
| madeaspack |
|
||
|
damn,thats a b**ch,i'll have to re do all the wolf wiring to the ecu?or is the loom from ecu to engine bay the same?
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| Nicko |
|
|||
|
loom from ecu to engine bay is the same im sure
_________________ Nicko |
|||
| Top | |
|||
| madeaspack |
|
||
|
i thaught that would be the case,cheers nicko
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |
