|
aaainoz |
|
||
|
Hi all I am upgrading from a donor car going to swap everything over including engine computer and loom from a BF into a BA Ute, to update my engine fresher one and up the 4 speed to a ZF6 .
My question is, is it possible I can do the loom swap without having to completely take the dash out? I know that I will need a custom tail shaft made up as it might be hard to find one. Thanks in advance. |
||
Top | |
Robert_au |
|
|||
|
{USERNAME} wrote: Hi all I am upgrading from a donor car going to swap everything over including engine computer and loom from a BF into a BA Ute, to update my engine fresher one and up the 4 speed to a ZF6 . My question is, is it possible I can do the loom swap without having to completely take the dash out? I know that I will need a custom tail shaft made up as it might be hard to find one. Thanks in advance. Dash out job BF looms were slightly different to BA. Having said that i'm running the H looms (floor loom) out of a BF in a BA with Minimal mods, i think the only wire i had to change in it was the Sport shift signal wire as in a BA it took the direction back over and around the drivers side where as the BF one went via passenger side. 100% best bet is to change every loom from the engine bay to the tail lights. Roof looms were the same between both so wont require changing.
_________________ Current Ride |
|||
Top | |
aaainoz |
|
||
|
Thanks for the info.
Would you still suggest completely replacing all the way to tail lights given the sedan donor car its all going into a ute? |
||
Top | |
Robert_au |
|
|||
|
{USERNAME} wrote: Thanks for the info. Would you still suggest completely replacing all the way to tail lights given the sedan donor car its all going into a ute? i'd stick with the ute looms i think and re rout the sport shift wire accordingly i think from memory it should only be 1 wire (it was in my instance but i was sedan to sedan) sedan looms will be too short for the ute. check check and compare visually between both.
_________________ Current Ride |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 27 guests |