|
shot |
|
|||
|
hey guys i'm looking at lowering my ba wagon but i have two large problems.
1) my insurance won't let me so i can't dump it too far 2) i dont have very much cash to spend on doing so. So my thoughts were to get the suspension from an xr6 ute so i can swap and if an accident did happen i could either swap or hope that they don't recognise, as i had my ef written off and it was lowered a fair bit and they didn't notice , any cheap options/idea's would be appreciated |
|||
Top | |
Disco Frank |
|
|||
|
cant see why they wont let you drop it to XR6 height...
and u cant use the rear leafs off a xr6 ute as the wago will be heavier and hence be lower.. best off gettign the rear leaves reset and a extra leaf put in ( allows for more weight and better handling ) and the Xr6 suspension on the front
_________________ RIP SCOTT |
|||
Top | |
Spork |
|
|||
|
I think you could use springs off the ute, but they might be heavier not softer! XR6 utes can carry an extra 600Kg in the tray or so.
_________________ Manual EL Gli.
|
|||
Top | |
jonbays |
|
||
|
In the AU there was a tickford suspesion kit option for the wagon. I have a mate with one factory fitted. It was about $680 from ford dealers.
It is nice and low not stupidly low though. AU and BA wagon very similar suspension may fit well. |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 40 guests |