Hi Guys,

I've been told by my local wheel alignment guys that I need to have my rear toe bolts + washers replaced. Aparrently when they try and tighten then they are undoing again and therefore my alignment cannot be corrected until I replace them.

Does anyone know where I might source them? I found these on ebay but they list rear upper but they look the same

http://www.ebay.com.au/itm/GENUINE-FORD ... SwfcVUIjGJ

Can anyone shed some light? I tried to get a set from a low km car at the wreckers but they are impossible to remove without dropping the rear cradle from what I can see.

Any help is appreciated

Just replace the nylock nuts
If you need to replace the bolts the cheats way is to tap the bolts in and cut the heads off/ tap them out and put new bolts in backwards ( no cradle drop)

Spot on Steve

Good luck with it bloke, i have dropped my cradle many many bloody times...

That's a load off my mind guys.

I was hoping it could be done without dropping the cradle.

Thanks for your advice

John.