i am wanting to convert my eb2 from auto to manual. i got the bits but not sure about the easyest way to do it, pls help.. cheers

what exactly do you need to know?

Basically, you switch the pedal boxes over which is a s**t of a job or buy a mal wood clutch pin.

Then pull the auto out, shifter, etc, etc

put the spigot bearing into the crank

bolt up the flywheel

bolt up the clutch

bolt up the bellhousing

connect the clutch

bolt up the gearbox, if the clutch isnt 100% aligned step on the clutch and push it in

connect the rear crossmember mount

put the tailshaft back in

swap the computers over or do the old resistor trick.

thanks for that, not to sure how i do the resistor trick, ols advise me how