|
| Aranthi |
|
|||
|
gday, im putting a EF t5 into my XF, i was wondering is there a way to tell if its a XR6 box or not? are they the same? also dumb question, where do i find the speedo cog?
|
|||
| Top | |
|||
| Krytox |
|
|||
|
XR and non XR are identical boxes.
Speedo Drive is on the Right Hand side of the extension housing (about mid way) The sender unit usually has a red coated pvc cable atteched to it. To see if its a later model box (eb2 onwards) look for the roofing Nail on the Left hand side of the case. see pic:
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| Aranthi |
|
|||
|
OH ok thanks mate, much appreciated
|
|||
| Top | |
|||
| bluecube |
|
|||
|
i thought the xr6 box has tapered input shaft bearings (wotever that means). just read it in my gregories manual.
mine is supposed to be an xr6 box too. dunno for sure tho
_________________ Sold my EB |
|||
| Top | |
|||
| stockstandard |
|
|||
|
Yep, I have also been told that the xr6 boxes use different bearings. Mal Wood also charges more for an e-series xr6 t5 than a 'standard' t5.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| ef_ridin_low |
|
||
|
the ea t5's havea higher ratio in 1st gear as well apparently the ea box is the better of the 3,, this is what i have been told any way
_________________ 95 evlmont fairmont, 5 speed manual, 3.45lsd, rebuilt and recond, port and polished head, wade 1521a cam,ems stinger, garret 3540 1.06 rear, tial 38mm waste gate, turbosmart "supersonic" bov, bosch greentop 42lb injectors,snort log manifold, heavy duty 5 puck ceramic clutch,fmic 600x300x76, |
||
| Top | |
||
| stockstandard |
|
|||
|
ef_ridin_low wrote: the ea t5's havea higher ratio in 1st gear as well apparently the ea box is the better of the 3,, this is what i have been told any way
Yes and no. The EAs do have a short 1st gear but it is a little too short for anything other than the 2.77 and 2.92 diffs that they came with. They are also the weakest of all the t5's.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| snap0964 |
|
|||
|
bluecube wrote: i thought the xr6 box has tapered input shaft bearings (wotever that means). just read it in my gregories manual. The EBII/ED/XG gregories is referring to the bearing between the input shaft and the mainshaft - XF/EA has 15 parallel rollers, while EBII onwards runs a tapered roller bearing.
I've had an EL XR6 T5 apart recently to check a synchro issue - I didn't find any difference in the bearings used compared to a std EBII T5. There were revisions to the synchro assy's, etc, but nothing greatly relevant to this discussion.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 82 guests |
