there is so much happening i dont know were too start
1 power windows wont go up without help
2 when i break there is a massive vibration in the sterrring have had rotors machined..
3 idiling very rough no acceleration
4 back power window switchs dont work half the time will go one way but not the other


HELP

1: Search, you need to re-adjust the regulator and Lubricate the bailey channels.
2: Replace rotors. and use Bendix Ultimates, NOT CT's
3: Replace Fuel filter, air filter and sparkplugs, possible cat blockage too.
4: Remove centre console buttons and examine all plugs and switches themselves. Also if your capable dissect the rear switches, clean, file contacts and re grease and re-assemble.

Hey mate.

What model is it first?

Mine has a slow drivers mech. Found out it has cracked the top plastic roller and the cable is grinding into it.
When the windows all the way down have a look with the door trim off the door and you'll see from the top if that's gone, or pull it out and inspect.

Did you get the rotors machined at a mechanics? Did it start after they worked on it? If not it's a tricky one. Usually with wheel bearings being stuffed it wobbles until the brakes are applied...

Idling rough I'd say same with checking ignition stuff, cap, leads etc. I was stumped by a rough idle untill I rechecked the leads and found genius me had put 3 and 4 on backwards...

With the switches if it's a E series, or N, I have 2 rear switches.

hi guys thanks for all the ideas much appreciated ... i am slowly workin through them (limited budget) acceleation has got much worse and even has trouble idling now.. changed spark plugs ..

window tracks = graphite powder

ive used the spray-on-grease-in-a-can crap before and it all went tacky and seized all my windows up