|
| elmeup |
|
||
|
hey i recently converted my el xr6 to a manual it has a manual pedal box in it brand new clutch cablle and a new clutch kit but my clutch pedal sits really high and the clutc cable is adjusted all the way out if its adjusted any lower there is hardly any free play and is difficult to get gears. is this normal for it to sit so high? does anyone else have this problem?
|
||
| Top | |
||
| ef_falcon_95 |
|
|||
|
It sits a tad higher than the brake pedal.
In the ford manual it says to have it 140mm from the floor. Mine is sit at 140mm and works good.
_________________ El XR6 Turbo |
|||
| Top | |
|||
| elmeup |
|
||
|
ok thanks i will go and measure mine now
|
||
| Top | |
||
| bry40l |
|
|||
|
i just adjusted mine to where it thought it was before and test drove it, then i had difficulty getting it into gear once i was driving so i gave it a tiny bit more and its fine, sits just above the brake pedal as mentioned
_________________ BF XR6 |
|||
| Top | |
|||
| elmeup |
|
||
|
ok got a new spring for the clutch pedal semms to be sitting better now also measured it and it sits around 145mm from the floor thanks for your help guys
|
||
| Top | |
||
| bradley4567 |
|
||
|
Hi, I know this is an old thread but you might be able to help me, I have the same problem
Do you measure it to the firewall or straight down? Also where did you get the clutch pedal spring from, mines missing
_________________ ef falcon daily driver |
||
| Top | |
||
| evxr6 |
|
|||
|
To the fire wall. Basically, you are measuring how far the pedal is travelling to fully disengage the clutch. That's why you measure to the firewall not the floor.
_________________ Current ride: MY03 Liberty RX Wagon |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 86 guests |
